ALFeeder_E.pdf - 第109页
2. Component tape reference specifications 5-3 Chapter 5 Specifications 2. Component tape reference specifications 2.1 Limitation of meandering T he meandering must be 1 mm or less per 100 mm within the span of 250 mm. Lim…
1. Auto loading feeder specifications
5-2
Chapter 5 Specifications
1.3 Tape loading/Tape auto-replace durations
No Item Duration Description
1 Tape loading duration Approx. 5 sec.
Duration from starting component tape loading after setting top of
component tape to specified position on feeder to completing component
tape feeding to pickup position.
2 Tape auto-replace duration Approx. 8 sec.
Duration to replace component tape in operation (1st tape) that runs out
of component with component tape to be added (2nd tape) automatically.
n
NOTE
• Durations above vary depending on the component tape size or feed pitch.
• Tape auto-replace duration includes discharging time of 1st tape that runs out of component.
2. Component tape reference specifications
5-3
Chapter 5 Specifications
2. Component tape reference specifications
2.1 Limitation of meandering
The meandering must be 1 mm or less per 100 mm within the span of 250 mm.
Limitation of component tape meandering
100
1 or less
250
Unit: mm
63505-KLU-30
2.2 Tensile testing
Fix one side of component tape. Pull the component tape applying a force of 1 N (102 gf). Place a
transparent plastic board with scale that is also a weight to measure the component tape.
Tensile testing
Reel
Apply a force
of 1N.
1N: 102 gf
Component tape
Fixing point
Transparent plastic board with scale
that is also a weight
63506-KLU-30
2. Component tape reference specifications
5-4
Chapter 5 Specifications
2.3 Top of component tape
►
Length of component tape of leading section
It must be 400 mm or longer including carrier tape with empty square pockets.
►
Square pockets
Square pockets must be sealed with cover tape (100 mm or longer).
Top of component tape
End of component tape
(160 mm or longer) Components
Top of component tape
(300 mm or longer)
Square pockets
(sealed 100 mm or longer)
Pull-out
direction
Cover tape
63507-KLU-30
2.4 End of component tape
►
Length of component tape of ending section
It must be longer than 160 mm but shorter than 350 mm including carrier tape with empty square
pockets.
►
Empty square pockets
Empty square pockets must be sealed with cover tape.
►
End of component tape
It must be detached from the hub for reel.
2.5 Component position in pocket
A0 A0
B0
B0
Tilt Rotation in horizontal direction Offset in vertical/horizontal direction
Component position in pocket
Center line of
pocket
Center line of
component
20° or less (Tape width: 8 mm)
10° or less
10° or less
0.5 mm or less
0.5 mm or less
63508-KLU-30
n
NOTE
Make sure to keep appropriate clearance around component to pick up component smoothly.