ALFeeder_E.pdf - 第66页
2. Preaparation for operation 3-20 Chapter 3 Setting up 3 S et the pr eset ho lder when th e compon ent tape is ne wly set . 1. Move down the reel holder of the feeder No. to be set Auto loading feeder . 2. Insert the pr…
2. Preaparation for operation
3-19
Chapter 3 Setting up
█
Procedure for setting up component tape without IT Option
The following procedure assumes that setting Auto Loading Feeder Capability list, performing Auto
loading feeder Optimizer, Setup Assignment are completed and Auto loading feeders are placed.
c
CAUTION
Check that tape guide type matches with Auto loading feeder size before setting Auto loading feeder on the feeder bank.
Additionally, remove a tape if it is pinched in dicharge assembly on top of tape guide section.
1
Prepare component tape to be set.
1. Open the [Monitor] - [Production] tab.
2. Check the parts name and set position in "Operating Navigation" box, and the tape guide
type in "Request size" of parts list.
Operating Navigation box
Tape guide type
Parts name,
Feeder set position
Auto Loading Feeder
is not used.
Request size
LL
L
M
S
2S
-
64301-KLU-40
2
Cutting/Folding top of component tape.
Cutting/Folding top of component tape
Cut from pocket side.
Check folded position.
Tape leveler
Insert component tape and
grip top and bottom of tape leveler.
63302-KLU-40
n
NOTE
See "1.2 Folding top of component tape" in chapter 2 for more detail.
c
CAUTION
Make sure to cut and fold the top of component tape correctly. Otherwise component tape may not be loaded.
2. Preaparation for operation
3-20
Chapter 3 Setting up
3
S
et the preset holder when the component tape is newly set
.
1. Move down the reel holder of the feeder No. to be set Auto loading feeder.
2. Insert the preset holder and hang the hooks on the boss on the rear of reel holder.
3. Attach a reel holder pad to the reel holder.
Setting preset holder
Example: Feeder exchange carriage for YSM20 series
Reel holder pad
Reel holder
Position to attach partition
Preset holder
63325-KLU-50
4
Set the tape reel, to be added newly or to be supplied, to preset holder.
5
Set the component tape to the loading unit.
1. While pressing down the tape clamp lever and pull the loading unit to front end.
2. (If the 1st reel spplies components) the clamp unit opens left and right by releasing the tape
clamp lever, the component tape in operation is fallen down below the loading unit.
Pulling out loading unit
Moving down the component tape in operation
Clamp unit opens
by releasing tape clamp lever
Tape clamp lever
Loading unit
Tape component
in operation
Tape component
in operation
63331-KLU-00
2. Preaparation for operation
3-21
Chapter 3 Setting up
3. Close the clamp unit and move the loading unit just before the end to make it not open.
4. While pressing the tape clamp lever, insert the component tape to the loading unit, then insert
the top of component tape to the set area as shown in the figure below.
Setting component tape
Loading unit
Component tape
to be added
Component tape in operation
Tape clamp lever
Keep pressing down
tape clamp lever
Tape set area
Clamp unit
Set top of component
tape in this area
63305-KLU-50
5. Insert the loading unit into feeder body and release the tape clamp lever.
Inserting loading unit
Loading unit
Tape clamp lever
63332-KLU-00
n
NOTE
A loading error may occur unless the loading unit is inserted into the end.