ALFeeder_E.pdf - 第65页
2. Preaparation for operation 3-19 Chapter 3 Setting up █ Procedur e for setting up component tape without IT Option The following procedure assumes that setting Auto Loading Feeder Capability list, perfor ming Auto load…
2. Preaparation for operation
3-18
Chapter 3 Setting up
2.2 Setting up component tape
2.2.1 Setting up component tape without IT Option
This section describes the procedure of setting the component tape without any optional software (IT
option).
Flowchart of setting up component tape
Without IT Option
Preparation
Prepare component tape
Set the Auto loading feeder
Auto Loading Feeder capability list
Auto Loading Feeder Optimizer
Setup Assignment
Y.FacT (P-TOOL)
Cut/Fold top of component tape
Start setting
Set component tape newly or
supply component tape
Newly
Check the [Monitor] - [Production]
screen or the [Setup Assignment]
screen
Set component tape
Set preset holder
Set component tape newly or
supply component tape
Start operation
No
Yes
Newly set ?
Set component tape to be added
to loading position
Move down component tape
in operation from loading unit
63301-KLU-30
n
NOTE
The flowchart above is the setting component tape without IT Option. The procedure or instruction screen may differ if using
IT Option.
2. Preaparation for operation
3-19
Chapter 3 Setting up
█
Procedure for setting up component tape without IT Option
The following procedure assumes that setting Auto Loading Feeder Capability list, performing Auto
loading feeder Optimizer, Setup Assignment are completed and Auto loading feeders are placed.
c
CAUTION
Check that tape guide type matches with Auto loading feeder size before setting Auto loading feeder on the feeder bank.
Additionally, remove a tape if it is pinched in dicharge assembly on top of tape guide section.
1
Prepare component tape to be set.
1. Open the [Monitor] - [Production] tab.
2. Check the parts name and set position in "Operating Navigation" box, and the tape guide
type in "Request size" of parts list.
Operating Navigation box
Tape guide type
Parts name,
Feeder set position
Auto Loading Feeder
is not used.
Request size
LL
L
M
S
2S
-
64301-KLU-40
2
Cutting/Folding top of component tape.
Cutting/Folding top of component tape
Cut from pocket side.
Check folded position.
Tape leveler
Insert component tape and
grip top and bottom of tape leveler.
63302-KLU-40
n
NOTE
See "1.2 Folding top of component tape" in chapter 2 for more detail.
c
CAUTION
Make sure to cut and fold the top of component tape correctly. Otherwise component tape may not be loaded.
2. Preaparation for operation
3-20
Chapter 3 Setting up
3
S
et the preset holder when the component tape is newly set
.
1. Move down the reel holder of the feeder No. to be set Auto loading feeder.
2. Insert the preset holder and hang the hooks on the boss on the rear of reel holder.
3. Attach a reel holder pad to the reel holder.
Setting preset holder
Example: Feeder exchange carriage for YSM20 series
Reel holder pad
Reel holder
Position to attach partition
Preset holder
63325-KLU-50
4
Set the tape reel, to be added newly or to be supplied, to preset holder.
5
Set the component tape to the loading unit.
1. While pressing down the tape clamp lever and pull the loading unit to front end.
2. (If the 1st reel spplies components) the clamp unit opens left and right by releasing the tape
clamp lever, the component tape in operation is fallen down below the loading unit.
Pulling out loading unit
Moving down the component tape in operation
Clamp unit opens
by releasing tape clamp lever
Tape clamp lever
Loading unit
Tape component
in operation
Tape component
in operation
63331-KLU-00