ALFeeder_E.pdf - 第69页
2. Preaparation for operation 3-23 Chapter 3 Setting up 2.2.2 Setting up component tape with IT Option T he following describes the flo wchart of setting component tape with IT Option. Start operation Flowchart of settin…
2. Preaparation for operation
3-22
Chapter 3 Setting up
5
Check the component tape setting.
The component tape is set correctly if the followings are applied.
1. The yellow LED lights up for 1 second if the component tape insertion is detected.
2. The yellow and green LEDs flash simultaneously for 4 seconds.
3. The green LED lights up after completing the component tape setting.
Yellow and green LEDs flash
simultaneously for 4 sec.
Yellow LED lights up for 1 sec.
Green LED lights up.
Completing
Completing component tape setting
Without IT Option
63306-KLU-30
6
Start the operation.
When the reel was newly set.
Pressing [START] button loads component tape, set in the loading unit, to pickup position and starts
operation.
When the reel was preset.
If the component tape in operation becomes empty, other component tape set in the loading unit
loads to pickup position and supplying component is continued.
2. Preaparation for operation
3-23
Chapter 3 Setting up
2.2.2 Setting up component tape with IT Option
The following describes the flowchart of setting component tape with IT Option.
Start operation
Flowchart of setting up component tape
With IT Option
LEDs flash continuously
Preparation
Scan component ID
No
Yes
Newly set ?
Set component tape to be added
to loading unit
Check setting status
Cut/Fold top of compontnent tape
Start setting
Prepare reel
On [Monitor] - [Production] screen
新テープを
Set component tape newly
Auto Loading Feeder capability list
Auto Loading Feeder Optimizer
Setup Assignment
Prepare Auto Loading Feeder
Set Auto Loading Feeder
Check [Monitor] - [Production]
screen or setup list
Set reel
Set component tape newly or
supply component tape
Set component tape newly
Set preset holder
Move down component tape in operation
63321-KLU-30
2. Preaparation for operation
3-24
Chapter 3 Setting up
█
Procedure for setting up component tape with IT Option
1
Prepare component tape to be set.
1. Select the [Monitor] - [Production] screen.
2. Check the component name and set position in "Operating Navigation" box, and tape guide
type in the Request column of Parts list.
Operating Navigation box
Tape guide type
Parts name,
Feeder set position
Auto Loading Feeder
is not used.
Request size
LL
L
M
S
2S
-
64301-KLU-40
2
Cutting/Folding top of component tape.
Cutting/Folding top of component tape
Cut from pocket side.
Check folded position.
Tape leveler
Insert component tape and
grip top and bottom of tape leveler.
63302-KLU-40
n
NOTE
See "1.2 Folding top of component tape"in chapter 2 for more detail.
c
CAUTION
Make sure to cut and fold the top of component tape correctly. Otherwise component tape may not be loaded.