MR8740T_Quick guide_eng_20191016H.pdf - 第56页

50 Attaching Connection Cords Outputting pulse waveforms Connect the connection cable to Model MR8791 Pulse Generator Unit. Required item: Commercially available cable (Half-pitch 50 pins) How to connect the cable to the…

100%1 / 172
49
Attaching Connection Cords
Outputting waveforms
Connect the connection cable to an SMB terminal of Model MR8790.
Required item: Model L9795-01/L9795-02 Connection Cable
• Model L9795-01 Connection Cable (mini-alligator clip type)
• Model L9795-02 Connection Cable (BNC output type)
How to connect the cable to an output terminal
Example: Model MR8790 Waveform Generator Unit
Output terminal
SMB connector
Attach the connection cable.
2
Attach the connection cable to a target.
Output
terminal
1
Insert the SMB connector of the connection
cable to an output terminal until the connector
clicks.
3
Attach the clips of the connection cable to a
target.
How to disconnect the cable from the output
terminal
Hold the head of the SMB connector (other than the
cable) and pull it out.
1
2
Preparing for Measurement
50
Attaching Connection Cords
Outputting pulse waveforms
Connect the connection cable to Model MR8791 Pulse Generator Unit.
Required item: Commercially available cable (Half-pitch 50 pins)
How to connect the cable to the output connector
1
Output connector
2
Attach the connection cable to a target.
1
Attach the connector of the connection cable
to an output connector of the module.
4
Attach the connection cable to a target.
How to disconnect the cable from the output
terminal
While holding down the buttons, pull our the connector.
Connector of connection cable
Buttons
Output connector
Connecting the connection cable
Output connector
10250-52A2PL: 3M (SCSI-2 connector, Centronics half-pitch, 50 pins, female)
Refer to “Model MR8791 Pulse Generator Unit” (p. 134).
• The metal shell of the 10250-52A2PL connector is equipotential to the chassis ground (frame ground).
• Use a lock-type connector to attach a harness to the connector of the module.
51
Attaching Connection Cords
Outputting voltage, current, and resistance
Attach the connection cable to
Model U8794 VIR Generator Unit
.
Required item: commercially available cable (D-sub 25 pins)
How to connect the cable to the output connector
1
Output connector
2
Attach the connection cable to a target.
1
Attach the connector of the connection cable
to the output connector of the module and
tighten the screws.
2
Attach the connection cable to a target.
How to disconnect the cable from the output
terminal
Loosen the screws of the output terminals.
Connector of connection cable
Buttons
Output connector
Connecting the connection cable
Output connector
09663527617, Harting (D-sub 25 pins, female)
Refer to “Specications of the output connector” (p. 136).
The metal shell of the 09663527617 connector is equipotential to the chassis ground (frame ground).
2
Preparing for Measurement