MR8740T_Quick guide_eng_20191016H.pdf - 第65页
59 Preparing Storage Devices (Recording Media) Formatting storage devices The instrument can format USB ash drives and the built-in drive. Once they are formatted, the “HIOKI_MR8740T” folder is created. IMPORT ANT Note …
58
Preparing Storage Devices (Recording Media)
Removing storage devices
Take the following procedure to remove the USB ash drive.
1
2
1
Click the remove button.
2
Click a storage device to be removed.
3
Remove the storage device according to the message.
This device can be
removed.
Remove the storage device.
This device cannot be
removed.
Check whether the storage device is being accessed.
Be sure to use the remove button to remove any storage device. Do not use Windows
®
Explorer or
an icon on the Windows
®
taskbar to remove the storage device.
59
Preparing Storage Devices (Recording Media)
Formatting storage devices
The instrument can format USB ash drives and the built-in drive. Once they are formatted, the
“HIOKI_MR8740T” folder is created.
IMPORTANT
Note that formatting a storage device deletes all the information stored on the storage device and
information deleted cannot be recovered.
> [Func] > [Explorer]
2
1
1
Click [Func].
2
Choose [Explorer].
Explorer appears.
3
Right-click a storage device to be formatted.
4
Click [Format] on the shortcut menu.
2
Preparing for Measurement
60
Supplying Power to the Instrument
2.6 Supplying Power to the Instrument
Refer to “Before turning on the instrument” (p. 18).
Turning on the instrument
On
1
3
2
To grounded
type outlet
1
Rear side
1
Connect the power cord to the power inlet
on the instrument.
2
Connect the plug to a grounded type outlet.
3
Set the main power switch on the back side
of the instrument to on.
The POWER orange LED lights up.
4
Press the start button to turn on the
instrument.
The splash screen appears followed by the waveform
screen.
5
Warm up the instrument for about
30 minutes.
This warm-up stabilizes the temperature in the
modules, yielding accurate measurement.
6
Execute zero-adjustment.
Refer to “2 Regulating the Zero Position (Zero-
Adjustment)” (p. 63).
7
Start a measurement.
Refer to “3.5 Starting/Stopping Measurement”
(p. 75).