3OM-996-005.pdf - 第208页
3.2.4 "Lead Data" T ab (Simple Shape) The corresponding tab sheet appears when "IC (Simple)", "Connector (Simple)", or "Other Leaded (Simple)" is selected in the "Component sh…
3.2.3 "Edge Data" Tab
The corresponding tab sheet appears when "Deform (Simple)" is se-
lected in the "Component shape" text box.
• Sheet Layout
When the "Edge Data" tab is pressed in the "Shape Data" tab sheet,
the following tab sheet appears.
Fig. 3C15 "Edge Data" Tab Sheet ("Deform (Simple)" Selected)
• Sheet Composition
Each parameter is displayed or can be entered.
Refer to "4.1.3 Basic Usage of Text Boxes" (Section 2) for the
detailed information on how to enter each parameter.
*1 Shape, *2 Detection Posn X [mm], *3 Detection Posn Y [mm]
0510-002 3-20
AIM01EDTP
*1
*2 *3
3.2 "Shape Data" Tab
Note
3.2.4 "Lead Data" Tab (Simple Shape)
The corresponding tab sheet appears when "IC (Simple)", "Connector
(Simple)", or "Other Leaded (Simple)" is selected in the "Component
shape" text box.
• Sheet Layout
When the "Lead Data" tab is pressed in the "Shape Data" tab sheet,
the following tab sheet appears.
Fig. 3C16 "Lead Data" Tab Sheet ("IC (Simple)" Selected)
• Sheet Composition
Each parameter is displayed or can be entered.
Refer to "4.1.3 Basic Usage of Text Boxes" (Section 2) for the
detailed information on how to enter each parameter.
0510-002 3-21
AIM01EDTP
*5
*6
*1
*2
*3
*4
3.2 "Shape Data" Tab
Note
0510-003 3-22 AIM01EDTP
(1) Component Shape: IC (Simple)
*1 Type
Different items will be displayed in "*5", depending on which
type is selected in this text box.
Gull Wing
The width and length are displayed in "*5".
J Bend, Straight
The width, length, and full length are displayed in "*5".
Leadless
The width and full length are displayed in "*5".
*2 # Of Types, *3 # Of Groups
*4 Extended setting
Different items will be displayed in "*6", depending on which
parameter ("Disable" or "Enable") is set in this text box.
Disable
When this is set in the "Extended setting" text box, the type
No., the direction, the number of leads, and pitch are dis-
played in "*6".
Enable
When this is set in the "Extended setting" text box, the type
No., the direction, the number of leads, the pitch, the position
(Latl Dir), the position (Long Dir), the missing lead start, the
number of missing leads, and the inspection condition are
displayed in "*6".
*5 Lead Type Data
Width [mm], Length [mm], Full Length [mm]
*6 Lead Group Data
Type No., Direction [°], # of Leads [pcs.], Pitch [mm], Posn
(Latl Dir) [mm], Posn (Long Dir) [mm], Missing Lead Start, #
of Missing Leads [pcs.], Insp Condtn
3.2 "Shape Data" Tab