OperationInstruction_Vsision XP.pdf - 第84页
Page 76 Vision XP+ V AC 4 Equipment 4.10 Control Cabinets Operating Instructions V ersion 1.5 Control Cabin et, Section 3 Fig. 4-6 1 Con trol Cabine t, Section 3 The third control cabinet houses the fo llowing components…
Vision XP+ VAC Page 75
4 Equipment
4.10 Control Cabinets
Operating Instructions
Version 1.5
Control Cabinet,
Section 2
Fig. 4-60 Control Cabinet, Section 2
The second control cabinet houses the following components:
A) Solid-State relay
B) Current alarm module
C) Phase monitoring
D) Thermal Protector for motor
E) Lifting motor load relay (process chamber)
F) Water pump contactor
G) Thermal protector for the water pump
H) Power controller
I) Overcurrent monitoring
J) 24 V power pack
K) Fuse
C
B D
G
I
H
E
J
K
F
A
K
Page 76 Vision XP+ VAC
4 Equipment
4.10 Control Cabinets
Operating Instructions
Version 1.5
Control Cabinet,
Section 3
Fig. 4-61 Control Cabinet, Section 3
The third control cabinet houses the following components:
A) Frequency converter bus distributor
B) The frequency converter
C) Load break switch
Control Cabinet,
Section 4
C
A
B
Fig. 4-62 Control Cabinet, Section 4
The fourth control cabinet houses
the following components:
A) The mains switch
B) The heater contactor
C) The line filter
C
B
A
Vision XP+ VAC Page 77
4 Equipment
4.11 Uninterruptible power supply VXP+ (option)
Operating Instructions
Version 1.5
4.11 Uninterruptible power supply VXP+ (option)
4.12 Transformer (option)
Fig. 4-63 USV
The UPS powers the PC, controller
and transport for approx. 15 min-
utes.
The following components have no
power during a power failure: heat-
er, heating fan, water pump, motor
for opening the chamber and the op-
tional exhaust air fan.
The machine must be switched off
at the master switch should the
power failure last longer than 15
minutes. The PC will autonomously
terminate any active programs.
The PC and UPS will switch off
completely after a certain time.
Note!
The user should not switch off the
PC separately.
The switch-off routine will not other-
wise execute correctly.
Fig. 4-64 Transformer
The transformer will be installed if
there is deviation of the input volt-
age of 230/400 V.