HS50_advance_level 2.pdf - 第22页
07/2002 Editio n Student G uide HS -50 Advanc ed II 1 Saf ety Co nsiderati on 8 6DIHW\LQVWUXFWLRQVI RUFORVLQJWK HSURWHFW LYHFRY HUV T o prevent a ll risk of injur y when cl osin g the prote ctive covers on th…
Student Guide HS-50 Advanced II 07/2002 Edition
1 Safety Consideration
7
RISK OF COMBUSTION
: Never carry out cleaning work using alcohol near a exposed light or flame.
: Never spray lubricant or cleaning agent from aerosol cans near a exposed light or flame.
: DO NOT SMOKE.
WARNING
: Never carry out cleaning work using alcohol near a exposed light or flame.
: DO NOT SMOKE.
: Always wear safety goggles and gloves when cleaning modules with concentrated ethyl alco-
hol.
: If you accidentally spray ethyl alcohol in your eyes, wash your eyes immediately with lots of
water.
07/2002 Edition Student Guide HS-50 Advanced II
1 Safety Consideration
8
6DIHW\LQVWUXFWLRQVIRUFORVLQJWKHSURWHFWLYHFRYHUV
To prevent all risk of injury when closing the protective covers on the machine, all personnel must
be required to follow the instructions below when closing the covers.
RISK OF INJURY HANDS IF THE PROTECTIVE COVERS ARE NOT CLOSED
CORRECTLY
(1)Protective covers
(2)Recessed grips
➠ When opening or closing the protective covers, always hold the covers by the recessed grips.
If the shock absorbing capacity of the protective covers reduces over time, for example, your
hands can easily be crushed if you do not close the covers using the recessed grips.
Student Guide HS-50 Advanced II 07/2002 Edition
1 Safety Consideration
9
6DIHW\LQVWUXFWLRQVIRUFKDQJLQJWKHFRPSRQHQWWDEOH
WARNING Never reach into the gaps between the component changeover table and
the placement system frame while the machine is running (item 1 in Fig. 1.1 - 2).
WARNING Always check that the component table is docked on the placement sys-
tem before connecting or disconnecting the power cable for the component changeover table at
the socket on the placement system (item 2 in Fig. 1.1 - 2).
WARNING NEVER connect the connecting cable for the component table to the
socket on the placement system and then operate the component table outside the machine via
the compressed air control unit (item 3 in Fig. 1.1 - 2).