CP-7-series Verification System Instruction manual(2.0E).pdf - 第30页
5. Explanation of Functions Edition 2.0 19 CP-7-series V erification System Instruction Manual 5.2.3 Manual Permission / Escape Permission This function can be used to exempt a specified slot from the verification operat…
5. Explanation of Functions
Edition 2.0 18 CP-7-series Verification System Instruction Manual
5.2.2 Next Production Verify
When in the “Changeover” table mode, this function performs a “next production
device check” at the idle table. While current production continues, the next production
recipe can be specified so that the idle table setup can be checked before the changeover
occurs, thereby reducing the time required for changeovers.
(1) The next-production recipe is
selected (only the changeover mode
program can be selected for the table
mode). The table not being used in
the current production is designated
for use in the next production.
Idle device table
(2) Next production verification
occurs at the table which is not being
used in the current production
(idle side).
(3) Upon completion of the current
production, the program is switched
to that for the next production. At this
time, the next production program
specified at the Handy Terminal blinks
in yellow. If the next production
verification has been completed,
automatic operation can begin
immediately.
Next production
verification occurs
With next production verification
Without next production verification
Production for recipe prior to
switching
Verification occurs
Production start
This changeover time
can be eliminated by
using the next
production verification
function
Recipe switching
Production start
5. Explanation of Functions
Edition 2.0 19 CP-7-series Verification System Instruction Manual
5.2.3 Manual Permission / Escape Permission
This function can be used to exempt a specified slot from the verification operation.
“Manual permission” can be specified for each slot, and “escape permission” can be
specified for each stage.
The device in an “exempt” slot (manual/escape permission) can be used in production
even though it has not undergone a verification operation by Handy Terminal and
Fujitrax Verifier.
Therefore, exempt devices (manual/escape permission) cannot be guaranteed to contain
the correct parts.
Moreover, when using Fujitrax Verifier, exempt devices will not be subject to Fujitrax
Verifier functions such as the “remaining parts count administration” and “feeder
maintenance administration” functions.
As the main purpose of the part verification system is to prevent the wrong parts from
being loaded, use of this “permission” function is not generally recommended.
The “permission” function should be used only as a temporary measure, such as when
the barcode printer fails, making it impossible to print out the required barcode labels
for the reels, etc.
5. Explanation of Functions
Edition 2.0 20 CP-7-series Verification System Instruction Manual
5.2.4 Off-Machine Changeover
An “off-machine changeover” refers to the process in which an idle device table (or a
spare device table) is brought to the Fujitrax Verifier, and a feeder setup is then
performed.
As off-line changeover is performed away from the machine, it is even possible to, for
example, setup the spare table while performing auto operation in Joint mode.
Changeover time is minimized by simply loading the prepared spare table onto the
machine.
Verification is
performed using
Verifier
With off-line changeover
Without off-line changeover
Verification occurs
Production start
Production start
This changeover
time can be
eliminated by an
off-line changeover.
Changeover occurs
Pallet change
Verifier
Handy Scanner
(1) Verification is performed
using the Verifier during machine
production operation.
(2) Handy Terminal is used at the
machine to perform a changeover.
(3) A new pallet is set in position.
Another verification is not required
at the machine.