CP-7-series Verification System Instruction manual(2.0E).pdf - 第52页
9. Using The Normal V erification Mode Edition 2.0 41 CP-7-series V erification System Instruction Manual 9.2.1 Device Check Start • A device check can be started by either of the following three methods. I. Select [Devi…
9. Using The Normal Verification Mode
Edition 2.0 40 CP-7-series Verification System Instruction Manual
9.2 Normal Verification Procedure 2
Device check start
Stage to be checked is determined
Slot to be checked is determined
Device check completed
Device comment reading
Mismatch
CP7V0004E
Match
No
No
Yes
Yes
ID which was read is
compared with recipe’s device
comment
Feeder set
All device checks completed
at check subject stage?
Device checks completed
on both sides?
: Operator tasks
: Machine processing
9. Using The Normal Verification Mode
Edition 2.0 41 CP-7-series Verification System Instruction Manual
9.2.1 Device Check Start
• A device check can be started by either of the following three methods.
I. Select [Device Check] on the machine control panel.
II. Select [1. Verify Check] at PDT-3100’s “Main Menu” and then press [ENTER].
PDT-3100’s Main Menu
III. With the main menu displayed at the Handy Scanner dialog box, read the "1"
barcode, and select "1. VERIFY CHECK".
Handy Scanner’s Main Menu
ENTER
[MAIN MENU]
1. VERIFY CHECK
2. PRE VERIFY CHECK
3. SET VERIFY RECIPE
4. PALLET SUPPLY
5. TEST READ
SELECT NO.=v
▼▲
CP7V0005
9. Using The Normal Verification Mode
Edition 2.0 42 CP-7-series Verification System Instruction Manual
9.2.2 Determining the Stage to be Verified
• The stage to be verified can be determined in the following three ways.
I. By using the PDT-3100’s to read the stage number barcode affixed on the
machine rear.
II. By selecting the desired stage from the PDT-3100’s “Select Start Stage”
screen.
PDT-3100’s Stage Selection Screen
III. With the “Input Stage No.” item displayed at the Handy Scanner dialog box,
use the Handy Scanner to read the Stage number barcode affixed on the
machine rear.
Handy Scanner’s Stage Selection Screen
Notes:
• The Verification operation must be performed for each stage.
• To perform a verification at Stage 2, for example, after Stage 1 has been selected, the
device check must be interrupted, and the verification must be started again.
• When using the Scanner, it is possible to return to the “Input Stage No.” step without
interrupting the device check. This is done by reading the “BACK” barcode.
ENTER/QUIT:
[VERIFY CHECK]
CP7V0006a
▲
SELECT START STAGE
1. STAGE1
2. STAGE2
SELECT STAGE NO.=v
▼▲