CP-7-series Verification System Instruction manual(2.0E).pdf - 第84页
10. Using the DC AUTO Mode Edition 2.0 73 CP-7-series V erification System Instruction Manual 10.4.2.5 DID Reading • DID data can be read in the following two ways. I. The DID barcode af fixed to the reel can be r ead to…
10. Using the DC AUTO Mode
Edition 2.0 72 CP-7-series Verification System Instruction Manual
10.4.2.3 Determining the Slot to be Verified
• If the stage to be verified was determined by removing a feeder, this step can be
skipped because the slot to be verified will also have been determined at that time.
• The slot to be verified can be determined in following three ways.
I. If a feeder is set in a slot where an LED is on at the verify subject stage, that
slot will become a verify subject if that feeder is removed.
II. By using the Handy Terminal to read the slot number barcodes affixed to
each slot.
III. By keying in the slot number from the PDT-3100’s numeric key pad.
PDT-3100’s Slot ID Reading Command Screen
Handy Scanner’s Slot ID Reading Command Screen
10.4.2.4 LED On at Slot to be Verified
• Only the LED at the slot to be verified is on.
• When subsequently setting feeders, the LEDs indicate which positions those
feeders should be set in.
ENTER/QUIT:
[VERIFY CHECK]
CP7V0007a
▲
STAGE1
READ SLOT ID LABEL
SLOT ID=v
10. Using the DC AUTO Mode
Edition 2.0 73 CP-7-series Verification System Instruction Manual
10.4.2.5 DID Reading
• DID data can be read in the following two ways.
I. The DID barcode affixed to the reel can be read to the Handy Terminal.
II. The DID can be entered using the PDT-3100’s alphabetic keys and numeric
key pad.
PDT-3100’s DID reading command screen
Handy Scanner’s DID Reading Command Screen
10.4.2.6 Extracting the Device Comment from the DID
• A DID Joint Symbol is used within the DID so that the device comment can be
extracted from the DID.
10.4.2.7 Obtaining the Device Comment from Fujitrax Verifier by Using the DID
• Fujitrax Verifier is queried to identify the device comment in the DID that was
read.
ENTER/QUIT:
[VERIFY CHECK]
CP7V0012a
▲
STAGE1 SLOT ID:1
ST:PARTS END
READ DID LABEL
DID=v
10. Using the DC AUTO Mode
Edition 2.0 74 CP-7-series Verification System Instruction Manual
10.4.2.8 Device Comment Comparison
• The machine searches the recipe to determine what the device comment should be
for the reel in the slot being verified.
• The machine then compares the search result with the delimiter or the device
comment obtained from Fujitrax Verifier.
• If there is a mismatch, the operator is requested to read the DID again.
• When using PDT-3100, if the compared device comments match, the system
proceeds to the verify check results screen.
• If the [ ] key is pressed at the PDT-3100 "Results" screen, or if several seconds are
allowed to elapse, the verification check for the current slot is ended, and a
"Waiting for next verification subject slot selection" status is established.
• If the scanner is being used, the system proceeds to the "waiting for feeder loading"
status if the comparison results are a match.
PDT-3100’s Verify Check Results Screen
Handy Scanner's "Waiting for Feeder Loading" Screen
NEXT:
[VERIFY CHECK]
CP7V0009
▲
STAGE1 SLOT ID:1
DID:01234
DEVICE COMMENT:01234
VERIFY CHECK OK
▲