CP43操作手册.pdf.pdf - 第12页
V ersion 5.0 x FCP IV -3 Operation
Introduction
This operation manual describes the operation procedures for the FCP IV-3.
Since there are parts of this manual that use specialized Fuji terminology, please
familiarize yourself with this terminology before reading this manual.
[Supervisor Computer]
The data used for FCP IV-3 operation is all managed at the supervisor
computer. The supervisor computer can be either an MCS-16F or MCS-30 but
for the purposes of this manual the term "MCS-30" is used as a general
reference to the supervisor computer. This term refers to the hardware unit of
the supervisor computer.
In addition to the 2 computer hardware units there are also 2 types of software
(MCS/2 and MCS/2H). In this manual the term "MCS/2H" is used as a
general reference to the software.
[Picking and Placing Parts]
Components of varying sizes from 1005 chips to SOJ 26 pin parts can be picked
and placed on the FCP IV-3. These parts that can be picked and placed are
referred to as "devices" in this manual.
ixVersion 5.0
FCP IV-3 Operation
Version 5.0
x
FCP IV-3 Operation
Part One
Machine Operation