CP43操作手册.pdf.pdf - 第23页
Part 1 Chapter 2 Operation of the Keys 1 – 10 V ersion 4.0 FCP IV -3 Operation
Chapter 2 Operation of the KeysPart 1
(d) [CYCLE STOP] button
This button is used to stop operation.
Press this button during automatic operation to cancel the
automatic operation mode at the end of the current sequence
and return the machine to the [START] button wait mode.
(e) [RESET] button
This button is used to reset alarms.
When an alarm occurs, an error message will be displayed and
this button will begin flashing. Press this button to clear the
alarm.
(f) [EMERGENCY STOP] button
This button is used to stop the FCP IV-3 instantly.
When this button is pressed, the machine’s 200 V power supply
is turned off. In addition, the button locks down when it is
pressed. Turn the button in the direction of the arrow
(clockwise) to release it.
(g) Operation panel selection switch
This selector switch is used to switch from the front to the rear
operation panel.
When the switch is set to a certain panel, the other panel cannot
be used.
Note: The [EMERGENCY STOP] and [CYCLE STOP] buttons on
both panels are always operational.
(h) Inching Keys
It is possible to inch the X, D1, D2, C and Fθ axes. Which of
these axes can be inched depends on the inching axis selection
keys mentioned in the previous section 3.2.
1 – 9
Version 4.0
FCP IV-3 Operation
Part 1 Chapter 2 Operation of the Keys
1 – 10Version 4.0
FCP IV-3 Operation
Chapter 3 Starting and Shutting DownPart 1
3. Starting and Shutting Down
This chapter explains how to start up and shut down the FCP IV-3. Also
explained is the reset-start procedure, which may be used to clear the
FCP IV-3’s memory.
3.1 Startup
This section explains everyday startup, and the reset-start and I/O check
start procedures.
3.1.1 Normal Operation
Use the following procedure to start the FCP IV-3.
(1) Boot up the MCS 30 Supervisor Computer. This computer
compiles production information transmitted from the
FCP IV-3 in Off Line mode.
(2) Set the circuit breaker.
The FCP IV-3’s main circuit breaker must be set to the ON
position before the FCP IV-3 can be turned on.
(3) Turn on the power .
Press the [POWER ON] button on the FCP IV-3 operation panel
to turn the machine on.
(4) After pressing the [POWER ON] button, ensure that the display
appears as follows:
Page 000
v1.10
Off line
CP_4.PROGRAM Prod 00000 Sche 00000
AUTO STEP LOADER PROGRAM SET
3A053C053C00
000000050000
jog X Y C
*
ST1.N**** D*** Er****
ST2.N**** D*** Er****
ST3.N**** D*** Er****
ST4.N**** D*** Er****
ST5.N**** D*** 0
ST6.N**** D*** 0
ST7.N**** D*** 0
STATUS
P Mode Product
Recovery 3 times
T Mode Joint
Machine Not Zero-Set
Press START
1 – 11Version 4.0
FCP IV-3 Operation