CP43操作手册.pdf.pdf - 第312页
Chapter 2 Other Messages Part 6 Outside Movement Area Since the data that has been input has caused the axis to move outside the permissible range of movement, the machine is waiting for the data to be reenter ed. Clear …
Chapter 2 Other MessagesPart 6
2. Other Messages
This chapter describes non error messages.
2.1 Requests to the Operator
Machine Not Zero Set
The machine is waiting for the operator to press the [START] button to
carry out zero setting.
Press START
The machine is waiting for the operator to press the [START] button.
Waiting for Reset SW
The machine is waiting for the operator to press the [RESET] button.
Turn Off Power
The machine is waiting for the operator to press the [POWER OFF]
button.
D??? Supply
The feeder at the device position shown is out of parts.
D??? Check
The feeder at the device position shown has parts but they are not being
picked up.
D??? unable to process
Vision processing cannot process the part picked.
Invalid Command
Data was improperly entered and must be reentered.
6 – 11Version 2.0
Chapter 2 Other MessagesPart 6
Outside Movement Area
Since the data that has been input has caused the axis to move outside the
permissible range of movement, the machine is waiting for the data to be
reentered.
Clear Off Complete
The clear off operation is complete and the machine is awaiting the next
command.
Sequence End Stop
One board has been produced, and the machine is awaiting the next
command.
Production Complete
Scheduled production is complete, and the machine is awaiting the
operator’s next command.
Set Proper
Machine is waiting for Proper data to be set. Set the correct Proper data.
Measure Nozzle Centers
After nozzles have been changed or after anything else occurs which
makes it possible that nozzle center values may have changed, then a
request will display to carry out nozzle center measurement
2.2 Machine Status
The messages displayed here indicate the status of the machine.
Ready
The machine is idle and is waiting for the operator to press one of the
function keys.
Operating Loader…
A board is being loaded or unloaded.
6 – 12Version 2.0
Chapter 2 Other MessagesPart 6
Waiting for PCB…
The machine is ready to receive a board.
Waiting for NEXT
The machine has finished processing the board and is waiting for the next
board.
Clearing Off…
The machine is clearing off all boards.
Stop After Current Board
The command [S STOP] has been pressed during automatic operation.
The machine will stop when the board currently being produced is
finished.
Measuring Proper…
The machine is measuring Proper data.
Normal Turnover
In turnover mode, sequences are executing in normal order.
Reverse Turnover
In turnover mode, sequences are executed in reverse order.
Discard picked part
All nozzles with parts on them are discarding those parts.
Changing over…
The machine is in the middle of automatic changeover.
Saving Data
Vision processing data is being saved to the memory disk.
6 – 13Version 2.0