CP43操作手册.pdf.pdf - 第310页
Chapter 1 Errors and Countermeasures Part 6 1.4 Alarms Which Prevent [RETURN] and Shut-down Vision System Alarm Cause: The vision processing system is hung. Remedy: Reboot the machine. If it appears to reboot normally , …
Chapter 1 Errors and CountermeasuresPart 6
Parts not set
Cause: In device change mode the parts have not been set on the next
device table.
Remedy: Set the parts.
Max D No. Error
Cause: In device change mode or in changeover mode the production
program calls for a device number greater than 80.
Remedy: Change the program so that it only calls for device numbers less
than 81.
No Production Program
Cause: A valid program has not been transmitted to the machine or a
program has not been chosen.
Remedy: Transmit a valid program to the machine or choose a program.
No Proper
Cause: Valid Proper data has not been transmitted to the machine.
Remedy: Transmit valid Proper data to the machine.
No Status
Cause: Valid Status data has not been transmitted to the machine.
Remedy: Transmit valid Status data to the machine.
GD Train Error
Cause: A device description download error was detected.
Remedy: Correct and re-transmit the program which produced the error.
6 – 9Version 2.0
Chapter 1 Errors and CountermeasuresPart 6
1.4 Alarms Which Prevent [RETURN] and Shut-down
Vision System Alarm
Cause: The vision processing system is hung.
Remedy: Reboot the machine. If it appears to reboot normally, survey the
situation before proceeding. If it does not reboot normally, and the alarm
occurs again, the vision processing board is probably defective.
6 – 10Version 2.0
Chapter 2 Other MessagesPart 6
2. Other Messages
This chapter describes non error messages.
2.1 Requests to the Operator
Machine Not Zero Set
The machine is waiting for the operator to press the [START] button to
carry out zero setting.
Press START
The machine is waiting for the operator to press the [START] button.
Waiting for Reset SW
The machine is waiting for the operator to press the [RESET] button.
Turn Off Power
The machine is waiting for the operator to press the [POWER OFF]
button.
D??? Supply
The feeder at the device position shown is out of parts.
D??? Check
The feeder at the device position shown has parts but they are not being
picked up.
D??? unable to process
Vision processing cannot process the part picked.
Invalid Command
Data was improperly entered and must be reentered.
6 – 11Version 2.0