CP43操作手册.pdf.pdf - 第314页
Chapter 2 Other Messages Part 6 Return to Cam Zero Cam axis is returning to its origin position. Calculating Placing Data Data necessary for placing parts is being processed. Vision Processor Executing Machine is waiting…
Chapter 2 Other MessagesPart 6
Waiting for PCB…
The machine is ready to receive a board.
Waiting for NEXT
The machine has finished processing the board and is waiting for the next
board.
Clearing Off…
The machine is clearing off all boards.
Stop After Current Board
The command [S STOP] has been pressed during automatic operation.
The machine will stop when the board currently being produced is
finished.
Measuring Proper…
The machine is measuring Proper data.
Normal Turnover
In turnover mode, sequences are executing in normal order.
Reverse Turnover
In turnover mode, sequences are executed in reverse order.
Discard picked part
All nozzles with parts on them are discarding those parts.
Changing over…
The machine is in the middle of automatic changeover.
Saving Data
Vision processing data is being saved to the memory disk.
6 – 13Version 2.0
Chapter 2 Other MessagesPart 6
Return to Cam Zero
Cam axis is returning to its origin position.
Calculating Placing Data
Data necessary for placing parts is being processed.
Vision Processor Executing
Machine is waiting for vision processing to be completed.
6 – 14Version 2.0
Chapter 3 MCS Error Code TablePart 6
3. MCS Error Codes
This chapter explains the MCS error codes that are especially related to
transmission with HELPS compatible machines.
Error Code: 2200750B
MCS Display: DTX750B Error
Cause: The transmit descriptor filename could not be obtained.
Remedy: Make sure that the machine is correctly registered in the Line
Descriptor.
The MCS 30 must be reset after data is entered in the Line
Descriptor. Exit MCS/2H (if the LMS system is also installed
exit LMS). Turn the MCS 30 power supply off and then back on.
Note: Refer to the MCS/2H System Operation manual for details about the
Line Descriptor.
Error Code: 22007511
MCS Display: DTX7511 Error
Cause: The program requested by the machine cannot be opened.
Remedy: Make sure that the program requested is stored in the MCS 30
computer. This can be checked using the function key [Dir_H].
Error Code: 22007512
MCS Display: DTX7512 Error
Cause: The MCS 30 computer was in the process of transmitting a
program when a program transmission request was received
from the machine (the communication pipe was being used
when the download request came from the machine).
Remedy: After waiting for some time, perform the download request
again. If the error still occurs at this time then cut the power to
the MCS 30 computer.
6 – 15Version 2.0