SIPLACE-SX4-DX4-用户手册.pdf - 第180页
Service Work COT inse rt 3.10.8 Replacing the Baffles 180 Service Manual SIPLACE SX4/DX4 3.10.8 3 . 1 0 . 8 R e p la c in g t h e B a f f le s Replacing the Baffles ► Read t he relevant se ction of the user manua l for y…
Service Work
3.10.7 Replacing the Control Valve [03097252-xx] COT insert
Service Manual SIPLACE SX4/DX4 179
3.10.7
3.10.7 Replacing the Control Valve [03097252-xx]
Replacing the Control Valve [03097252-xx]
Parts, equipment and tools
▪ Valve assembly SX4 [03097252-xx]
Overview
Removal
► Loosen the screws fastening the COT insert and extract it slightly from the machine. (See "3.10.1
Replacing the COT Insert Assembly [03080552-xx]" [ ➙ 170])
► Dismantle the cover plate over the valve.
► Unplug the electricity and compressed air cables from the control valve (1). Mark their positions, to
make clear assignment easier later on.
► Loosen the fastening screws and remove the control valve.
Installation
► Installation is performed by following the above instructions in the reverse order.
► Control valve
1
Service Work
COT insert 3.10.8 Replacing the Baffles
180 Service Manual SIPLACE SX4/DX4
3.10.8
3.10.8 Replacing the Baffles
Replacing the Baffles
► Read the relevant section of the user manual for your machine.
Parts, equipment and tools
▪ Guide plate (for number please refer to the parts catalogue.)
Overview
1. Empty-tape duct assembly
2. Baffles
1. Deflection plate
2. Screws fastening the deflection plate (left and right)
1
2
Service Work
3.10.8 Replacing the Baffles COT insert
Service Manual SIPLACE SX4/DX4 181
Removal
► Loosen the two screws fastening the baffle insert and remove the baffle.
Installation
► Installation is performed by following the above instructions in the reverse order. Also observe the
following instructions:
CAUTION
Do not dismantle the empty-tape duct.
Only replace the deflection plate assembly. Do not dismantle the empty-tape duct.
NOTICE
Inner baffle
When using tape reels with deep pockets, you may need to remove the inner baffle. Refer to
the operating manual of your machine for details.
All screws are accessible in the installed state. The baffles can therefore be replaced inside the
machine.
CAUTION
Installation instructions
► Reposition the deflection plate on the tape channel, if you are not using any components >
15 mm.
CAUTION
The deflection plate fits tightly into the tape channel.
Sharp-edged objects can damage the coating in the tape channel, which can then lead to com-
ponent tapes getting jammed at the edges. This could then cause a head crash.
► Never use sharp-edged objects to position the deflection plate.
► If necessary, use a wooden wedge or, as shown in the following diagram, a brush with
wooden handle.