SIPLACE-SX4-DX4-用户手册.pdf - 第223页

Measuring Equipment and Tools Programming Cable for PXS240 Sensor [03073330-xx] Service Manual SIPLACE SX4/DX4 223 4.10 4 . 1 0 P r o g r a m m in g C a b le f o r P X S 2 4 0 S e n s o r [ 0 3 0 7 3 3 3 0 - x x ] Progra…

100%1 / 298
Measuring Equipment and Tools
Setting Gauge for Actuator [03049740-xx]
222 Service Manual SIPLACE SX4/DX4
4.8
4.8 Setting Gauge for Actuator [03049740-xx]
Setting Gauge for Actuator [03049740-xx]
4.9
4.9 Belt Tensioning Device for Turning Station DLM [03063649-01]
Belt Tensioning Device for Turning Station DLM [03063649-01]
1. Setting gauge
2. Terminal strip
This device is used for setting the tension of the toothed
belt at the turning station.
This part is available from introduction of the turning sta-
tion DLM version 06 [00341780-06].
Measuring Equipment and Tools
Programming Cable for PXS240 Sensor [03073330-xx]
Service Manual SIPLACE SX4/DX4 223
4.10
4.10 Programming Cable for PXS240 Sensor [03073330-xx]
Programming Cable for PXS240 Sensor [03073330-xx]
4.11
4.11 Setting Gauge for Sonar Sensors [03048764-xx]
Setting Gauge for Sonar Sensors [03048764-xx]
4.12
4.12 Setting Gauge for Sonar Sensors [03076989-xx]
Setting Gauge for Sonar Sensors [03076989-xx]
Version 1 – UB-PROG4-V31 (old PXS240)
Version 2 – UB-PROG2
Setting gauge for ultrasonic sensors [03048764-xx]
Setting gauge for ultrasonic sensors in X quad lane, X op-
tions, SX series and SX options
Wen you place the gauge on the conveyor, make sure
that the designation for the relevant conveyor remains
visible.
▪ 3mm gap for the X conveyor
▪ 2mm gap for the SX conveyor
Measuring Equipment and Tools
Gauge for Stopper Setting [03067221-xx]
224 Service Manual SIPLACE SX4/DX4
4.13
4.13 Gauge for Stopper Setting [03067221-xx]
Gauge for Stopper Setting [03067221-xx]
4.14
4.14 Mapping Test Plate 520x300 mm [03067312-xx]
Mapping Test Plate 520x300 mm [03067312-xx]
4.15
4.15 Mapping Test Plate 560x460 mm [03076118-xx]
Mapping Test Plate 560x460 mm [03076118-xx]
4.16
4.16 ACT Calibration Plate, Single Set, for Quad Lane [03073073-xx]
ACT Calibration Plate, Single Set, for Quad Lane [03073073-xx]
Stopper setting gauge for fitting the stopper unit on the
holding bracket
A special mapping plate with a width of 300 mm has been
developed for the quad lane machines. These machines
can only be mapped with this mapping plate, as the con-
veyor can not be set to a width of 450 mm.
Mapping plate 560x460 mm
ACT calibration plate, single set, for quad lane
[03073073-xx]