SIPLACE-SX4-DX4-用户手册.pdf - 第181页

Service Work 3.10.8 Replacing the Baffles COT insert Service Manual SIPLACE SX4/DX4 181 Removal ► Loosen the two screws fastening the baffle insert and remove th e baffle. Installation ► Installation is performed by fo l…

Service Work

COT insert 3.10.8 Replacing the Baffles

180 Service Manual SIPLACE SX4/DX4

3.10.8

3.10.8 Replacing the Baffles

Replacing the Baffles

► Read the relevant section of the user manual for your machine.

Parts, equipment and tools

▪ Guide plate (for number please refer to the parts catalogue.)

Overview

1. Empty-tape duct assembly

2. Baffles

1. Deflection plate

2. Screws fastening the deflection plate (left and right)

Service Work

3.10.8 Replacing the Baffles COT insert

Service Manual SIPLACE SX4/DX4 181

Removal

► Loosen the two screws fastening the baffle insert and remove the baffle.

Installation

► Installation is performed by following the above instructions in the reverse order. Also observe the

following instructions:

CAUTION

Do not dismantle the empty-tape duct.

Only replace the deflection plate assembly. Do not dismantle the empty-tape duct.

NOTICE

Inner baffle

When using tape reels with deep pockets, you may need to remove the inner baffle. Refer to

the operating manual of your machine for details.

All screws are accessible in the installed state. The baffles can therefore be replaced inside the

machine.

CAUTION

Installation instructions

► Reposition the deflection plate on the tape channel, if you are not using any components >

15 mm.

CAUTION

The deflection plate fits tightly into the tape channel.

Sharp-edged objects can damage the coating in the tape channel, which can then lead to com-

ponent tapes getting jammed at the edges. This could then cause a head crash.

► Never use sharp-edged objects to position the deflection plate.

► If necessary, use a wooden wedge or, as shown in the following diagram, a brush with

wooden handle.

Service Work

COT insert 3.10.9 Replacing the Feed Control [03082077-xx]

182 Service Manual SIPLACE SX4/DX4

3.10.9

3.10.9 Replacing the Feed Control [03082077-xx]

Replacing the Feed Control [03082077-xx]

Parts, equipment and tools

▪ Insert control assembly SX4 [03082077-xx]

Overview

Removal

► Switch off the machine and secure it to prevent unauthorized reactivation. Observe the instructions

in section "1.2 Preparatory Work..." [ ➙ 12].

► Dismantle the nozzle changer over the feed control. (See "3.8.1 Replacing the Nozzle Changer"

[ ➙ 152])

► To gain better access, you may need to disconnect the COT insert and pull it slightly out of the ma-

chine. Observe the instructions in section Installation Position for COT Insert (Table Positions).

Alternatively, you can improve access by removing the upper section of the component camera.

► Unplug all electrical connections to the insert control. You may want to mark their positions, to make

clear assignment easier later on.

► Loosen the screws fastening the insert control and remove the insert control from the machine.

Installation

► Follow the removal instructions in reverse order for installation.