SIPLACE-SX4-DX4-用户手册.pdf - 第227页

Settings 5.1.1 Setting the Machine Covers Settings on the Basic Machine Service Manual SIPLACE SX4/DX4 227 5 5 S e t t in g s Settings 5.1 5 . 1 S e t t in g s o n t h e B a s ic M a c h in e Settings on the Basic Machin…

100%1 / 298
Measuring Equipment and Tools
Component Sensor Protective Cap (CPP) [03080984-xx]
226 Service Manual SIPLACE SX4/DX4
4.20
4.20 Component Sensor Protective Cap (CPP) [03080984-xx]
Component Sensor Protective Cap (CPP) [03080984-xx]
4.21
4.21 Unlocking Hook for Manual Table [03038882-xx]
Unlocking Hook for Manual Table [03038882-xx]
Component sensor protective cap for the CPP head
[03080984-xx]
In the event of an error (FCU failure,), the X feeders can
only be removed from the manual tables of the DX1/2 and
DX4 machines by using this unlocking hook.
Settings
5.1.1 Setting the Machine Covers Settings on the Basic Machine
Service Manual SIPLACE SX4/DX4 227
5
5 Settings
Settings
5.1
5.1 Settings on the Basic Machine
Settings on the Basic Machine
5.1.1
5.1.1 Setting the Machine Covers
Setting the Machine Covers
Overview
NOTICE
Example
The following settings are shown using the example of an SX2 machine. The procedure is the
same for other machines. Any differences will be explicitly indicated.
Settings (example of SX2 shown)
1. Setting the cover guidance
See "5.1.1.1 Setting the Cover Guidance" [ ➙ 228]
2. Setting the cover switch
See "5.1.1.2 Setting the Cover Switch" [ ➙ 229]
3. Setting the cover switch centering
See "5.1.1.3 Setting the Cover Switch Centering De-
vice" [ ➙ 230]
4. Setting the actuator
See "5.1.1.4 Setting the Actuator" [ ➙ 230]
5. Setting the bottom stop
See "5.1.1.5 Setting the Bottom Stop" [ ➙ 231]
6. Setting the rollers
See "5.1.1.6 Setting the Cover Rollers" [ ➙ 232]
Settings
Settings on the Basic Machine 5.1.1 Setting the Machine Covers
228 Service Manual SIPLACE SX4/DX4
5.1.1.1
5.1.1.1 Setting the Cover Guidance
Setting the Cover Guidance
Cover guidance (example of SX2 shown)
The cover guidance transitions must be set when the
gantry changer doors are closed, so that the guidances
are flush with one another. Make sure that there is no pro-
truding edge, against which the cover guide roller could
be knocked.