SIPLACE-SX4-DX4-用户手册.pdf - 第232页
Settings Settings on the Basic Machine 5.1.1 Setting the Machine Covers 232 Service Manual SIPLACE SX4/DX4 5.1.1.6 5 . 1 . 1 . 6 S e t t in g t h e C o v e r R o lle r s Setting the Cover Rollers Cover rollers (example o…
Settings
5.1.1 Setting the Machine Covers Settings on the Basic Machine
Service Manual SIPLACE SX4/DX4 231
5.1.1.5
5.1.1.5 Setting the Bottom Stop
Setting the Bottom Stop
► Check the settings by opening and carefully closing the cover several times:
▪ The metal bracket is parallel to the opening and does not scrape against the switch
▪ The plastic centering feature is positioned centrally to the centering device and does not scrape
against the switch.
▪ When the cover is opened, there is no discernable resistance of the cover rollers in the guidance
rails.
▪ Shortly before the bottom cover position, there is no resistance audible apart from the centering en-
gaging and the engaging of the metal bracket in the cover switch.
▪ The cover can be closed completely, so that the swing cover closes smoothly at the top with the side
covers.
Bottom stop (example of SX2 shown )
NOTICE!
There are two variations of the bottom stop. These are
not exchangeable with one another. When replacing
these two variants, you also need to replace the gantry
changer doors and the guidances.
1. Variant 1:
2x buffer cover guidance [03075364-xx]
1x DIN EN ISO7380-M3 x 25-A2-70 [03045198-xx]
1x DIN985 - M3 - A2-70 [00328897-xx]
2. Variant 2:
Right stop [03086295-02]
Left stop [03086313-02]
Buffer with studs, type no. 1284 [03072728-01]
Guide roller (example of SX2 shown)
► Adjust the bottom stop for the guide rollers so that the
actuator does not touch the housing of the switch and
so that the upper cover is parallel to the side machine
cover. The foam rubber on the bottom stop must lie
against the roller, without the cover being pressed
back up again. This must be set for both sides.
Settings
Settings on the Basic Machine 5.1.1 Setting the Machine Covers
232 Service Manual SIPLACE SX4/DX4
5.1.1.6
5.1.1.6 Setting the Cover Rollers
Setting the Cover Rollers
Cover rollers (example of SX2 shown)
► Set the cover roller by using the grub screw, so that it is inserted by at least 75% into the guidance.
Lock the roller with a setscrew DIN915-M8x16 [00304354-xx] or DIN-EN-ISO4026-M8x16-A2-21H
[03025582-xx].
NOTICE
Missing O-rings
► Replace the following missing O-rings on the roller: O-ring 8.5x1.6 [03078577-xx]
Settings
5.2.1 Overview of Electrics Electrical and Control Settings
Service Manual SIPLACE SX4/DX4 233
5.2
5.2 Electrical and Control Settings
Electrical and Control Settings
5.2.1
5.2.1 Overview of Electrics
Overview of Electrics
CAUTION
Observe the detailed circuit diagrams!
For more detailed information, refer to the circuit diagrams folder of your machine.
► SIPLACE SX4/DX4 detailed circuit diagrams [00196711-xx] (German/English)
► Circuit diagram SIPLACE X-Series S [00197021-xx] (German/English)