SIPLACE-SX4-DX4-用户手册.pdf - 第202页
Service Work Manual Table (DX4) 3.13.3 Removing the Front Section of the Manu al Table 202 Service Manual SIPLACE SX4/DX4 3.13.3 3 . 1 3 . 3 R e m o v in g t h e F r o n t S e c t io n o f t h e M a n u a l T a b le Remo…
Service Work
3.13.2 Removing the Back Section of the Manual Table Manual Table (DX4)
Service Manual SIPLACE SX4/DX4 201
3.13.2
3.13.2 Removing the Back Section of the Manual Table
Removing the Back Section of the Manual Table
Parts, equipment and tools
Select the correct spare part:
▪ Rubber mallet
Overview
Removal
► Loosen the two screws fastening the back section.
► Pull the back section out of the pins and remove it. You may need to use a rubber mallet to help you.
Installation
► Follow the removal instructions in reverse order for installation.
CAUTION
Back part, dummy feeder
Do not operate the machine without the back part of the manual table or without the dummy
feeder.
Machine type Designation Item No.
DX4 Table module MT 40 03082703-xx
DX1/DX2 Table module MT 60 03081585-xx
Table module MT 30 03082639-xx
Manual table (using example of DX1/DX2)
1. Front part
2. Back part
3. Screw fastening the back section, left
4. Screw fastening the back section, right
CAUTION
Do not lift by holding on to the centering bar.
► Only use the handles provided to lift the back section. The fixture bar is used to stabilize
and position the feeders. Take care not to bend it.
Service Work
Manual Table (DX4) 3.13.3 Removing the Front Section of the Manual Table
202 Service Manual SIPLACE SX4/DX4
3.13.3
3.13.3 Removing the Front Section of the Manual Table
Removing the Front Section of the Manual Table
Parts, equipment and tools
▪ Rubber mallet
Overview
Manual table – front section (using the example of the
DX1/DX2)
1. Front part
2. Screws fastening the front section (4x)
1. Front part
2. Feeder locking device
This is fixed from below with 6 screws.
Service Work
3.13.3 Removing the Front Section of the Manual Table Manual Table (DX4)
Service Manual SIPLACE SX4/DX4 203
Removal
► Dismantle the back section of the manual table. (See "3.13.2 Removing the Back Section of the Man-
ual Table" [ ➙ 201])
► Loosen the fastening screws of the feeder locking device and then remove the board.
► Loosen the 4 screws fastening the front section.
► Pull the module out of the locating pins. You may need to use a rubber mallet to help you.
Installation
► Follow the removal instructions in reverse order for installation.
If there is a WPC at the same location, perform the follow-
ing two steps as well:
► Dismantle the WPC docking rail (1).
► Dismantle the left side of the insert mechanism (2).
Loosen the 4 fastening screws (3) on the underside
and the 2 fastening screws on the top of the empty
tape duct.
► Dismantle the stoppers (1).
You may need to lower the cutter onto the support
plates (2). (See Replacing the Cutter [03063781Sxx])