00198227-03_UM_MaterialSetupAssistant_2.3-R17-1_DE_EN.pdf - 第220页
Workflow with Flexible Family Setup Performing Presetups with Material Reuse 220 ASM Material Setup Assistant 2.3 (R17-1) ASM Material Setup Ass i st a n t 2 . 3 Context menu for placement (produc tion of the recipe on t…
Workflow with Flexible Family Setup
Producing Recipes on the Line
ASM Material Setup Assistant 2.3 (R17-1) ASM Material Setup Assistant 2.3 (R17-1) 219
5.9.1
5.9.1 Information and Context Menu
Information and Context Menu
Tool tip information about placement (production of recipe on the line)
► Move the mouse over the placement (1).
⇨ A tool tip (2) with important information about the placement will be shown.
Tool tip information about placement
Workflow with Flexible Family Setup
Performing Presetups with Material Reuse
220 ASM Material Setup Assistant 2.3 (R17-1) ASM Material Setup Assistant 2.3
Context menu for placement (production of the recipe on the line)
► Right-click with the mouse on the placement (1).
⇨ The context menu (2) will open.
Context menu for placement
5.10
5.10 Performing Presetups with Material Reuse
Performing Presetups with Material Reuse
Material reuse means that the material from one setup (n) can be used again in the next but one setup
(n+2 rule) on the same line. Material can also be used on other lines again, if usage on the same line is
not possible. If this material comes back from the lines to the presetup area, the reuse will be shown to
the user.
In the following section, we add to the previous work steps and plan by using materials from the first set
-
up in the third setup.
The material from the first setup is brought from the line to the presetup area
► Wait until the last board has been placed.
► Undock the changeover table from the location.
⇨ The changeover table will be automatically logged off at the location.
► Bring the changeover table to the presetup area of your line.
► Move the changeover table into the docking station.
► Scan the control barcode Signal material reuse. Scanning this control barcode sets the docking sta
-
tion from mode Setup verification into the mode Signal material reuse.
⇨ You will be shown whether this feeder is "required" or "not required".
WARNING
Manual "Set Status to In Progress" and "Finish Task"
In the normal process, the functions Set Status in Progress and Finish Task are automatically
performed by the system. Manual Set Status to In Progress and Finish Task should only be
used in exceptions and may only be used by trained specialist personnel.
Workflow with Flexible Family Setup
Performing Presetups with Material Reuse
ASM Material Setup Assistant 2.3 (R17-1) ASM Material Setup Assistant 2.3 (R17-1) 221
Changeover table in the docking station - feeder status
1. Required feeder: shines green
2. Feeder not required: flashes red
The feeders shining green remain in the presetup area
► Remove the feeder from the changeover table and place it in the feeder rack. The LED will shine
green again, as soon as the feeder has been placed correctly on the feeder rack.
The feeders flashing red will be torn down
► Tear down the feeders in Setup Center.
► Bring the material back to the warehouse and use ASM Material Manager to place it back into stor
-
age.
Performing process for all changeover tables
► Perform the complete process with all of the changeover tables coming back from the line.