00198227-03_UM_MaterialSetupAssistant_2.3-R17-1_DE_EN.pdf - 第223页

Workflow with Flexible Family Setup Performing Presetups with Material Reuse ASM Material Setup Assistant 2.3 (R17-1) ASM Material Setup Ass istant 2.3 (R17-1) 223 5.10.1.1 5 . 1 0 . 1 . 1 P r e s e t u p P r o c e s s w…

Workflow with Flexible Family Setup

Performing Presetups with Material Reuse

222 ASM Material Setup Assistant 2.3 (R17-1) ASM Material Setup Assistant 2.3

5.10.1

5.10.1 Setup Preparation with Material Reuse

Setup Preparation with Material Reuse

Location-based flashing of feeders on the AFP hardware

Pre-setups with material reuse are shown by two icons in the ASM Setup Center application (1 and 2).

ASM Setup Center - show feeder status

If there are feeders with reuse (LED is green) on the AFP hardware (feeder rack or docking station),

these feeders can be made to flash with the function (1). This function helps to better identify the

required feeders for the location to be set up. The flashing of the feeder for a location is also enabled by

scanning the setup list barcode.

Icon Description

Enabled:

All feeders will flash green for the selected location. For clarity, the feeders which are al

ready green (material reused but not for this location) will be switched off. Feeders with

material that cannot be reused will continue to flash red.

Enabled: The LEDs on the feeders will change back to the original state.

NOTICE

Scanning the setup list barcodes

If there are feeders with reuse (LED is green) on the AFP hardware, these feeders can also be

made to flash by scanning the setup list barcode.

Workflow with Flexible Family Setup

Performing Presetups with Material Reuse

ASM Material Setup Assistant 2.3 (R17-1) ASM Material Setup Assistant 2.3 (R17-1) 223

5.10.1.1

5.10.1.1 Presetup Process with Material Reuse

Presetup Process with Material Reuse

► If flashing has been enabled for a location in a setup, pull these feeders from the AFP hardware.

► In ASM Setup Center, open the Target track view via the menu bar Extras => Target track view. This

dialog shows the track on the table to be set up onto which the just pulled feeder needs to be placed.

► Place the feeder on the changeover table. Verification is not needed.

► Move the changeover table into the docking station.

► Set up the additional picked material and verify the material, until the changeover table is completely

set up.

► Repeat this same procedure for the other changeover tables in the setup.

If all tables are torn down completely, the setup job is automatically completed. No manual intervention

is necessary. After that, the tables can be brought to the relevant production line.

5.10.1.2

5.10.1.2 Material Reuse in the Pre-Setup Area

Material Reuse in the Pre-Setup Area

Depending on the configuration in ASM Material Manager, specify if components are to be kept in the

pre-setup area or not. See also "2.3.2 Selecting Material Reuse" [ ➙ 163].

▪ Use the Permanent or Calculated option.

– The LED on the feeder lights green permanently => DO NOT tear down

▪ Without permanent material reuse (Never option)

– The LED on the feeder flashes red => tear down

Workflow with Flexible Family Setup

Performing Presetups with Material Reuse

224 ASM Material Setup Assistant 2.3 (R17-1) ASM Material Setup Assistant 2.3