SM-131-006.pdf - 第134页
Device Name Chip Mounter Block Name Page No. Unit Name Revision Model Item GXH -1 Chapter 5 Head Section 7. MSB W hole Cleaning and Lubricat ion Procedures (15) After wiping off the old grease of the O -ring outer cove r…
Device
Name
Chip Mounter
Block Name
Page No.
Unit Name
Revision
Model Item GXH-1
Chapter 5 Head Section
7. MSB Whole Cleaning and Lubrication Procedures
(14) Detach the head section attaching jig from the nozzle shaft assy. <Fig. E61>
- Please support the jig by hand in removing the bolts (M1.6×L4) because springs are
set for the each nozzle shaft in the nozzle shaft assy. If an operator does not support
the jig, the springs will jump out as soon as detaching the jig. And, put marks on the
jig like Fig. E61 to distinguish the attaching position. This mark will help your
operations later.
- Be careful do not add force to the shaft when you support the shaft section by hand.
And check that the serial No.’s are marked on the shaft. If not, manage the shafts
positions to reset to the outer cover.
Fig. E61
Mark
Lower Rotor and
Outer Cover
Nozzle Shaft
and Spring
M1.6×L4
No.1
0605-001
5-32
Device
Name
Chip Mounter
Block Name
Page No.
Unit Name
Revision
Model Item GXH-1
Chapter 5 Head Section
7. MSB Whole Cleaning and Lubrication Procedures
(15) After wiping off the old grease of the O-ring outer cover section < Fig. E62>, apply
grease to the O-ring outer circumference slightly. And, clean the V-packing <Fig. E62>,
too. After wiping off the soil cleanly, apply grease to the V-packing shaft washer slightly.
Fig. E62
O-ring
O-ring
Retainer
V-Packing
Part No.-S29
0605-001
5-33
Device
Name
Chip Mounter
Block Name
Page No.
Unit Name
Revision
Model Item GXH-1
Chapter 5 Head Section
7. MSB Whole Cleaning and Lubrication Procedures
• Cleaning and Lubrication of Retainer Section
(16) Wipe up the retainer section of the lower rotor outer cover inside to remove the old
grease with a rag dipped in alcohol.
Use rags made from lint-free materials.
* Rag width: approximately 6 mm to 7 mm and length: approximately 130 mm
Reference: Cleaning Tools
Fig. E63
Fig. E64
Rag
Allen Wrench (Long 1.5 mm )
Hold here by fingers
so that it is taut.
Cleaning of Retainer
2-Lines
Head Side View
0605-001
5-34