SM-131-006.pdf - 第188页

Device Name Chip Mounter Block Name Page No. Unit Name Revision Model Item GXH-1 Chapter 9 Cutter Section 3. Replacement of Cutter Axis Servomotor Amplifiers 3.1 Location of Cutter Axis Servomotor Amplifiers (Drivers) 3.…

100%1 / 325
Device
Name
Chip Mounter
Block Name
Page No.
Unit Name
Revision
Model Item GXH-1
Chapter 9 Cutter Section
2. Replacement of Cutter Axis Motor
2.1 Attachment of Cutter Axis Motor
2.2 Phase Z Origin Adjustment of Cutter Axis Motor
Perform the phase Z origin adjustment of the cutter axis motor at the place approximately 20
mm (the distance between the end of the cutter base and the end of the cutter movable
section) away from the end of the cutter base.
(Position for Cutter Replacement)
• Origin Stroke : 620 mm (cf. "4. Location of Limit Sensors")
The phase C detection jig is required.
0406-001
9-2
Fig. I5 Driving Belt
Tension Adjusting Bolt
Fig. I4 Status of Attached Motor
Motor Driving Belt Tension
Width : 9 mm
Unit Weight : 0.25 g/cm
2
Span : 87.8 mm
Attachment Tension : 44 N
20 mm
Device
Name
Chip Mounter
Block Name
Page No.
Unit Name
Revision
Model ItemGXH-1
Chapter 9 Cutter Section
3. Replacement of Cutter Axis Servomotor Amplifiers
3.1 Location of Cutter Axis Servomotor Amplifiers (Drivers)
3.2 Detachment of Cutter Axis Servomotor Amplifier
(1) Disconnect Connectors CN1A, CN1B, CN2, and CN3 located just before the amplifier.
(2) Disconnect the power lines located under the amplifier.
Supply 200 V AC : L1, L2, and L3
Control 200 V AC : L11 and L21
Motor : U, V, W, and PE
(3) Detach the amplifier from the panel. The amplifier is fastened with screws.
0406-001
9-3
Cutter Axis in Section A
(A63)
Cutter Axis in Section B
(A63)
Backup Axis in Section NA
(A53)
Fig. I6 Bottom 1 Side of Main Machine (Block BA)
Cutter Axis in Section D
(A63)
Cutter Axis in Section
C
Backup Axis in Section NC
(A53)
Fig. I7 Bottom 3 Side of Main Machine (Block BC)
Device
Name
Chip Mounter
Block Name
Page No.
Unit Name
Revision
Model ItemGXH-1
Chapter 9 Cutter Section
3. Replacement of Cutter Axis Servomotor Amplifiers
3.3 Setting of Cutter Axis Servomotor Amplifier
3.4 Attachment of Cutter Axis Servomotor Amplifier
Refer to "2. Replacement of Cutter Axis Motor" and "3. Replacement of Cutter Axis
Servomotor Amplifiers" for how to attach the cutter axis servomotor amplifier.
Note the connection of the wires.
Fig. I8 Front Cover Opened
Axis Selection Switch
• Set the address.
Cutter ABCD
All Addresses: 6
0406-001
9-4