00197395-03_AI_3D_Sensor-Koplan_X-Serie_S_DE_EN.pdf - 第144页
4 Appendix 4.2 Excerpt from the assembly instructions "SIPLACE X-Series S, SX-Series V3 stationary camera type 25/33 (GigE)" [00197710‑xx] 144 Assembly Instructions / Montageanleitung SIPLACE X-Series S 3D-Sens…
4 Appendix
4.2 Excerpt from the assembly instructions "SIPLACE X-Series S, SX-Series V3 stationary camera type 25/33
(GigE)" [00197710‑xx]
Assembly Instructions / Montageanleitung SIPLACE X-Series S 3D-Sensor 06/2020 143
Spacer plates for locations 2 and 3
Fig.100: Narrow spacer plates for locations 2 and 3
Fig.101: Correct labeling of spacer plates
CAUTION!
Incorrect labeling
In a few cases, these spacer plates
are supplied with incorrect labeling.
.
► Compare your spacer plates with the
diagram.
If the label does not match the diagram,
correct the label.
– FC: This side must be on top for FC
cameras and Q10 magazines
(Smart Pin Support).
– IC: This side must be on top for IC
cameras.
Fig.102: IC top
IC and FC are marked on the top and bot-
tom of the spacer plates.
When fitting an IC camera, make sure that
the IC lettering (1)
faces upwards.
4 Appendix
4.2 Excerpt from the assembly instructions "SIPLACE X-Series S, SX-Series V3 stationary camera type 25/33
(GigE)" [00197710‑xx]
144 Assembly Instructions / Montageanleitung SIPLACE X-Series S 3D-Sensor 06/2020
Spacer plates for locations 1 and 4
Fig.103: Spacer plates
Wide spacer plate for locations 1 and 4 with
plug-in screws for fixture to machine frame
Fitting the spacer plates
Fig.104: Left: location 2 and 3; right: location 1 and 4
► Use the screws (M6x45) to fix the spacer plates to the screw fixing points in the machine
frame (1)
. Make sure that the IC label indicates upwards.
► At position (2), tighten the two screws (M6x20) for the camera suspension holder, until the
screw shaft protrudes approx. 15mm above the mount.
4 Appendix
4.2 Excerpt from the assembly instructions "SIPLACE X-Series S, SX-Series V3 stationary camera type 25/33
(GigE)" [00197710‑xx]
Assembly Instructions / Montageanleitung SIPLACE X-Series S 3D-Sensor 06/2020 145
IC Camera Type 33: Fixing the Camera Module
Fig.105: Lower section of camera
► Hook the upper holes (1) on the lower
section of the camera onto the screws
already fitted.
► The camera can only be fitted at one
height. Fix the lower section of the
camera accordingly with the two bot-
tom screws(2).
► Tighten all four screws.
CAUTION
Observe the installation height
After installation, check the installation height. The camera may not protrude over the upper
edge of the conveyor!
Otherwise there is the danger of a crash!
Locations 2 and 3
► If you do not have to install an FC camera at the same location, continue by attaching the
camera cables (see section Connecting the Cable).
► If you also install an FC camera at the same location, proceed with section Fitting the FC
Camera of Type 25 - Location 2 and 3
Locations 1 and 4
► Continue by attaching the camera cables (see section Connecting the Cable).