CP7 Series Level3 Tutorial Manual.pdf - 第86页
3.3.5 PCU Cylinder Sensor Procedure: 1. Turn the sensor ON then OFF again. 2 . Set the sensor position 0.5 mm from the ON position. Set the flow control 5 revolutions from the fully closed position. 3. Set the volume to …
3.3.2 Table Interlock Sensor
Procedure:
1. Place a 1 mm feeler gauge between the stopper and the jig in order to
adjust the pallet interlock sensor (5). Adjust both interlock sensor
amplifier volumes to 1/4 from the MIN. When the feeler gauge is
inserted, the sensor should turn off. When the feeler gauge is removed,
the sensor should activate.
3.3.3 Pallet Stopper
Procedure:
1. To adjust the pallet stopper (7), inch the D-axis to zero pulses, and
manually extend the stopper to contact the table using the solenoid
valve.
2. Loosen the stopper bracket and move from left to right to find the
middle of the play. Secure the bracket in this position.
3. Loosen the sensor with a small screwdriver and tighten at position 0.5
mm from where the sensor activates.
4. The speed controller should be set 3 rotations from the fully closed
position.
3.3.4 Pallet Air Cylinder Sensor
Procedure:
1. Ensure that the pallet is in the downward position.
2. Inch the pallet from the zero counter position until the air cylinder
becomes visible.
3. Set the retract end sensor at 0.5 mm from the ON position. The
downward speed controller should be set 5 revolutions from fully
closed.
4. Manually raise the pallet to the upward position and set the advance end
sensor at 0.5 mm from the ON position. The upward speed controller
should be set 4.5 revolutions from fully closed.
Speed Controller
CP7T33013
Chapter 3 3.3 D-Axis Pallet Adjustments
Edition 2.0 3-14 CP-7-series Level 3 Tutorial
3.3.5 PCU Cylinder Sensor
Procedure:
1. Turn the sensor ON then OFF again.
2. Set the sensor position 0.5 mm from the ON position. Set the flow
control 5 revolutions from the fully closed position.
3. Set the volume to MAX for the PCU insert clamp check sensor. Verify
that the PCU is detected.
Chapter 3 3.3 D-Axis Pallet Adjustments
Edition 2.0 3-15 CP-7-series Level 3 Tutorial
Notes:
Chapter 3 3.3 D-Axis Pallet Adjustments
Edition 2.0 3-16 CP-7-series Level 3 Tutorial