CP7 Series Level3 Tutorial Manual.pdf - 第89页
Notes: Chapter 3 3.4 T raining Evaluation Edition 2.0 3-18 CP-7-series Level 3 T utorial
3.4 Training Evaluation
Circle the most appropriate answer from the list below.
(1) It is necessary to remeasure the pickup position following:
a. Replacing the D-axis motor.
b. Adjusting the D-axis servo amplifier.
(2) Which of the following statements is true?
a. “Pickup Position T1” (or T2) is the amount of D-axis movement
required to move feeder slot 1 to the pickup position at station 1.
b. “Pickup Position T1” (or T2) is the amount of D-axis movement
required to move the last feeder slot to the pickup position at
station 1.
(3) When confirming the response from the pallet upper end sensor, what
size of feeler gauge should be placed under the pallet?
a. 0.3 mm.
b. 0.5 mm.
(4) What must be done before it is possible to inch the D-axes.
a. Retract the table stoppers.
b. Unclamp the PCU.
Chapter 3 3.4 Training Evaluation
Edition 2.0 3-17 CP-7-series Level 3 Tutorial
Notes:
Chapter 3 3.4 Training Evaluation
Edition 2.0 3-18 CP-7-series Level 3 Tutorial
Chapter 4
PQ, FQ, and RQ-
Axes
Objective:
Given a CP-7-series machine, technical
documentation and required tools,
remove, replace and calibrate the PQ, FQ
and RQ-motors to FUJI specifications.