00190725-01.pdf - 第33页

Additionally required testing aids: • Plasticine Supply source: Siemens AG AUT 5 V Serv ice Rupert-Mayer-Str . 44 D-81359 München Tel. 089/722 61200 FAX: 089/722 24260 Us er’ s Ma nual Auto Cal Prog ram 3 R equirem ents …

3.4 Prerequisites for MS-102, MS-128 and MS-132

3.4.1 System Requirements

• Winchester

• Interface Software V 2.5 and higher

• Station Software from MSX.200.xxx

• Axis Card Software Version 2.5 and higher

• BASIC from version 6.0 (contained on the hard disk/Winchester)

NOTE:

The new HP printer requires the use of BASIC Version 6.21.

This version is delivered along with the AutoCal program (see chapter 4, "Set of Diskettes").

3.4.2 Testing Aids Required

• AutoCal program, available on 2 different sets of diskettes:

—

AutoCal program on 5 DD diskettes, item no. 00322032

—

AutoCal program on 4 DD diskettes and 1 HD diskette, item no. 00322032

(For details refer to chapter 4. Supply source - see below)

NOTE

The following testing aids must be available for the performance of the Routine Check (all measuring rou-

tines are carried out). For individual checks, only the testing aids listed in chapter 9 are required.

The following testing aid are delivered along with the machine:

• Steel nozzle, type 104, item no. 00301435

• New MA-zero point gauge (with 2 holes: ∅ 3.5 mm and ∅ 5 mm), item no. 00120060

• New adjusting gauge for component table ("iron", with 2 holes), item no. 00120040

• Adjusting gauge for adhesive application head, with tip, item no. 00310314

• Teach panel, external, item no. 00132207

• Calibrating nozzle for coplanarity module, item no. 00301711

• VISION 2 Calibration plate, item no. 00132070

• 2 Test sockets for nozzle changer

Large test socket (for special holder), item no. 00311659

Small test socket (for normal holder), item no. 02102021

• Nozzle top part = nozzle insert, item no. 00302566

*) also included with nozzle changer accessories kit

Parts to be ordered:

• Nozzle adapter, type 117, item no. 00300659

• Mapping plate and centering square for MS-102/128, contained in the Mapping Case, item no. 00132040

• Mapping plate and centering square for MS-132, contained in the Mapping Case, item no. 00134100

3 Requirements for Use User’s Manual AutoCal Program

3.4 Prerequisites for MS-102, MS-128 and MS-132 Softwareversion 114.xxx

3 - 4

Additionally required testing aids:

• Plasticine

Supply source: Siemens AG

AUT 5 V Service

Rupert-Mayer-Str. 44

D-81359 München

Tel. 089/722 61200

FAX: 089/722 24260

User’s Manual AutoCal Program 3 Requirements for Use

Softwareversion 114.xxx 3.4 Prerequisites for MS-102, MS-128 and MS-132

3 - 5

This page intentionally left blank!

3 Requirements for Use User’s Manual AutoCal Program

3.4 Prerequisites for MS-102, MS-128 and MS-132 Softwareversion 114.xxx

3 - 6