EUKYX-199-2100_G5S2_Instruction_Vol2_E.pdf - 第142页
EUKYX 2-29 199-2100 3.3 Operation (C04) Set-up D ata Graphic Development F2B24 ( C 0 4 _ 01 ) Conv eyor Us ing these but tons, whether or not the conv eyor width is setup i n the pattern program chan ge operation , is se…
EUKYX
2-28199-2100
3.3 Operation
(C03_03)
Sequence
Set one of the following options to specify the timing of PEC recognition implementation. It is
recommended that "After Pick-up" should be set in normal cases.
The components must meet the following requirements.
When "After Pick-up" is selected, a component is picked up and the component recognition is
performed on the component while the PCB is being transferred to the PCB positioning section.
Since the component is already picked up, it can be placed soon after the PEC recognition
operation is performed, shortening the time to finish a PCB.
After Pick-up: The PEC recognition operation is performed after a component is picked up.
Before Pick-up: The PEC recognition operation is performed before a component is picked up.
This parameter should be selected when the PEC recognition operation cannot
be performed with a component being picked up.
Note
EUKYX
2-29199-2100
3.3 Operation
(C04) Set-up Data
Graphic
Development
F2B24
(C04_01)
Conveyor
Using these buttons, whether or not the conveyor width is setup in the pattern program change
operation, is set.
EUKYX
2-30199-2100
3.3 Operation
(C05) Support Pin Data
Graphic
Development
F2B25
(C05_01)
Support Pin
Using the selection buttons, select "Common" or "Individual" to set.
Common
When selected, it is set as the line common data.
Individual
When selected, it is set as the machine individual data.
When the line consists of two or more machines and the line common data is set up, the data
is shared by all the machines (SIGMA-G5II) in the line. However, when the machine individual
data is set up, each machine has its own individual data to be set.
Line Common Data
Machine Individual
Data
Machine Individual
Data
Machine Individual
Data
F2B26
Note