X3_X4_Series machine.pdf - 第180页

4 Setting up and commissioning User manual SIPLACE X-Series 4.2 Delivery configuration and transport Sof tware Version SR.601.xx 11/2005 US E dition 180 Forks across the PCB conveyor 4 4 Fig. 4.2 - 4 Contact s urfaces - …

User manual SIPLACE X-Series 4 Setting up and commissioning

Software Version SR.601.xx 11/2005 US Edition 4.2 Delivery configuration and transport

179

Fig. 4.2 - 3 Contact surfaces - Forks parallel to the direction of PCB transport

(1) Contact surfaces for the forks of the fork-lift

4 Setting up and commissioning User manual SIPLACE X-Series

4.2 Delivery configuration and transport Software Version SR.601.xx 11/2005 US Edition

180

Forks across the PCB conveyor 4

Fig. 4.2 - 4 Contact surfaces - Forks across the direction of PCB transport

(1) Contact surfaces for the forks of the fork-lift

WARNING 4

Please note the following points

before

you raise the placement machine in order to avoid irre-

versible damage to the machine:

– The distance between the forks must be between 800 and 900 mm. The attachment surfaces

for the fork-lift are shown in Fig. 4.2 - 4

. The maximum distance between the contact surfaces

is 1120 mm. NEVER increase the distance between the forks so that the machine is lifted on

the side parts of the machine frame, since this would deform the machine frame.

User manual SIPLACE X-Series 4 Setting up and commissioning

Software Version SR.601.xx 11/2005 US Edition 4.3 Infrastructure at the installation location

181

Æ Make sure that the forks are evenly loaded when you lift the machine. A firm support between

the forks and placement machine will prevent the machine tilting when it is raised. This will

also prevent a one-sided load on the machine feet, which would deform the fixing of the ma-

chine feet. We recommend that a second person watch the machine as it is raised, and make

sure that the machine does not tip to one side when lifted with the fork-lift.

4.2.4.4 Points that MUST be noted when transporting the machine

WARNING 4

When you are transporting the machine, make sure that

all

the feet are clear of the floor. If they

are not clear, the feet will drag along the floor or bump into obstacles. This could damage the

machine foot fixing in the machine frame.

4.3 Infrastructure at the installation location

4.3.1 Recommendations concerning the quality of the foundation

The foundation for the placement machine should be firm and flat since dynamic forces can create

vibrations when the placement machine is used. The size of the vibrations depends on the con-

struction of the foundation. The following are suitable provided that the floor loading parameters,

etc., are not exceeded:

– Reinforced concrete ceiling constructions, e.g. ceilings in production halls

– Reinforced concrete floor slabs, e.g. concrete floors in production halls without a basement

– Rooms with double floors, provided that a stable foundation is included in the space between

them. The same set-up conditions apply to this intermediate foundation, which can be made

from steel girders or concrete.

4.3.1.1 Machine weight and floor loading

The machine weight and floor loading values can be found in section 4.1, page 173.