X3_X4_Series machine.pdf - 第256页
5 Tasks on the machine User manual SIPLAC E X-Series 5.3 Carrying out a walk-through inspection Software Version S R.601.xx 11/2005 US Edition 256 5.3.7 Using spi ndles for large t ape ree ls Æ Insert spi ndles i nto the…
User manual SIPLACE X-Series 5 Tasks on the machine
Software Version SR.601.xx 11/2005 US Edition 5.3 Carrying out a walk-through inspection
255
5.3.6 Inserting separating plates in the tape container
Æ The separating plate has different edges and can be inserted into the tape container in two
ways. If spindles are used, the recesses for the spindles in the separating plate point upwards
(see item 4 in Fig. 5.3 - 4
). If you do not use spindles, the
rounded
edge of the separating plate
points up (see item 5 in Fig. 5.3 - 4
).
Æ Insert the separating plates as shown in Fig. 5.3 - 4 and remember that the smallest division
of the tape container is a 2x division. This will help avoid placement errors.
Æ Check that the separating plates engage in the same positions on the three guide rails. Oth-
erwise the separating plate will be offset or bent.
5
Fig. 5.3 - 4 Separating plates in the tape container
(1) Guide rail for the separating plates
(2) Waste tape container
(3) Tape container
(4) Position of the separating plate if spindles are used
(5) Position of the separating plate if no spindles are used
(6) Sliding surfaces for the tape reels
5 Tasks on the machine User manual SIPLACE X-Series
5.3 Carrying out a walk-through inspection Software Version SR.601.xx 11/2005 US Edition
256
5.3.7 Using spindles for large tape reels
Æ Insert spindles into the separating plates when using large tape reels.
PLEASE NOTE 5
We recommend that you use spindles if the tape reel diameter exceeds 15" (381 mm)". This will
ensure that the feeder modules operate reliably.
Fig. 5.3 - 5 Inserting spindles for large reels
5
(1) Tape container
(2) Position of the spindles
(3) Separating plate
(4) Spindle (enlarged)
User manual SIPLACE X-Series 5 Tasks on the machine
Software Version SR.601.xx 11/2005 US Edition 5.4 Setting up the feeder modules
257
5.4 Setting up the feeder modules
5.4.1 Notes on handling feeder modules
Feeder modules are precision devices. You should therefore handle the feeder modules with care.
Æ Avoid bumping feeder modules into obstacles.
Æ Do not drop the feeder modules.
Æ Always use suitable tools for preventive maintenance.
5.4.2 Removing X feeder modules from the component table
5
Fig. 5.4 - 1 Removing X feeder modules from the component table
(1) Removal handle
(2) Status display
(3) LCD display
(4) Latch for locking the X feeder modules