X3_X4_Series machine.pdf - 第235页
User manual SIPLAC E X-Series 4 Setting up and commissioning Software Version SR.601.xx 11/2005 US Edition 4.4 Sett ing up the placement machine 235 4.4.1 6 Making fi nal adj ustme nt s to the plac ement mac hine Æ Place…
4 Setting up and commissioning User manual SIPLACE X-Series
4.4 Setting up the placement machine Software Version SR.601.xx 11/2005 US Edition
234
4.4.15.3 Aligning the placement machine with respect to the line
Æ Position the placement machine on the free location on the line using the fork-lift.
WARNING 4
Lower the placement machine slowly. A second person should look underneath to ensure
that all the machine foot touch the floor at the same time. If the machine feet on one side hit
the ground hard, the fixings may be damaged.
4
4.4.15.4 Aligning the placement machine with the air cushion transport system
Æ Place the four air cushions of the air cushion transport system beneath the machine frame.
Æ Raise the placement machine and align it with respect to the line.
Æ Check the distance from the PCB conveyor system of the adjacent machine. It should be be-
tween 1 mm and 3 mm.
Æ Lower the placement machine.
4
Fig. 4.4 - 25 Contact positions for the air cushion transport system
(1) Contact surfaces for the air cushion transport system
User manual SIPLACE X-Series 4 Setting up and commissioning
Software Version SR.601.xx 11/2005 US Edition 4.4 Setting up the placement machine
235
4.4.16 Making final adjustments to the placement machine
Æ Place the machine's spirit level on the panels of the PCB conveyor in placement area 1 in
both the X and the Y directions (see Fig. 4.4 - 26
). The PCB conveyor width is preset:
Single conveyor 210 mm
Dual conveyor, track 1 136 mm
Dual conveyor, track 2 210 mm 4
PLEASE NOTE: 4
On the dual conveyor, place the spirit level only on the outer panels of the machine for ad-
justing in the X direction.
Æ Measure the distance between the top edge of the PCB conveyor belt and the floor. This dis-
tance should be 800 mm, 900 mm, 930 mm or 950 mm.
4
Fig. 4.4 - 26 Adjusting the placement machine in the X and Y directions
Æ Use the size 36 fork wrench to adjust the adjusting screw M24x2x120 (item 1 in Fig. 4.4 - 27)
so that the label on the machine spirit level does not deviate from the zero point for the re-
quired PCB transport height.
4 Setting up and commissioning User manual SIPLACE X-Series
4.4 Setting up the placement machine Software Version SR.601.xx 11/2005 US Edition
236
4
Fig. 4.4 - 27 Setting the height for the outer machine feet
4
(1) Adjusting screw M24x2x120 for adjusting the height
(2) Outer machine foot
(3) Clamp
(4) M24x90 hexagon socket head screw
Æ Check the required PCB transport height.
Æ If the placement machine has been aligned, use the size 19 Allen key to tighten the hexagon
socket head screws M24x90 (Pos. 4) for holding the clamps on all the outer machine feet
(item 3).
Æ Unscrew the middle machine feet using a hook wrench 135 - 145 until they are seated firmly
on the ground.