1OM-1050-002.pdf - 第113页

Refer to "Attachment and Detachment of T ape Feeders to Feeder Carriage" in the instruction manual of tape feeders for details. (3) After the tape feeder has been attached, close the feeder work area safety doo…

1.2.3 Preparation for Components and P.C.B.’s

••

• Installation of Tape Feeders

(1) Open the feeder work area safety door of the feeder carriage

where the tape feeders should be installed.

Fig. 1C14

(2) Check which type of the tape feeder should be installed in which

slot No. (Fdr. No.). After that, install the tape feeders correctly.

Fig. 1C15

CAUTION

The tape feeders should be seated securely.

Otherwise, they may collide with the feeder installa-

tion error detection sensors or pick-up errors will oc-

cur.

0110-003 3 - 9

AFO01EOPP

1.2 Preparation before Automatic Operation

Refer to "Attachment and Detachment of Tape Feeders to Feeder

Carriage" in the instruction manual of tape feeders for details.

(3) After the tape feeder has been attached, close the feeder work

area safety doors.

Press the [FEEDER READY] buttons and check that the lamps

of these buttons are ON.

••

• Preparation for P.C.B.’s

In the case of normal automatic operation, confirm that P.C.B.’s are

prepared in the input machine.

When this machine is operated singly (actual placement test,

etc.), follow the steps below.

(1) Set the [OPERATION] switch to the "SETUP" side and open the

front safety door.

Fig. 1C16

(2) Set a P.C.B. on the L conveyor (input conveyor) such that the

P.C.B. detection sensor is turned on (the red LED of the sensor

illuminates).

Fig. 1C17 P.C.B. Flow Direction: From Left to Right

1.2 Preparation before Automatic Operation

0307-004 3-10 AFO01EOPP

L Conveyor

(Input Conveyor) (P.C.B. Positioning Section)

R Conveyor

(Output Conveyor)

L Conveyor P.C.B. Detection L Sensor

P.C.B. Flow Direction

2%$

219'410

5612

56#46 '0#$.'

4705'672

12'4#6+10

.1%-

20.%*#0)'

1.3 Start of Automatic Operation

Operation Procedure

(1) Confirm that the front safety door is closed.

(2) Set the [OPERATION] switch on the front operation panel to the

"RUN" side and be sure to remove the selection key from the ma-

chine.

Fig. 1C18

(3) Check the surroundings of the machine and confirm safety before

starting the automatic operation.

CAUTION

Check carefully that there is no person around the

moving mechanisms of the machine. (Especially, the

other side of machine operation).

Make sure that no objects (tools, parts, etc.) remain

within the moving mechanisms of the machine.

(4) Press the [OPN. MODE] button on the submenu bar on the touch

screen. The "OPN. MODE" window opens. Press the [PLACE] but-

ton (entitled "RUN MODE") in the "Run Mode" tab sheet.

Fig. 1C19