1OM-1050-002.pdf - 第19页
0207-003 1 8 AFO01EOPP 2.3 Precautionary Items before Operation • Only qualified personnel should come within the operating area of the machine. CAUTION • Inspect the devices before starting the automatic operation. CAUT…
2.3 Precautionary Items before Operation
2.3 Precautionary Items before Operation
WARNING
• Remove the selection key of the [OPERATION] switch before
operating the machine automatically.
The selection key must be used to set the [OPERATION] switch to the
"SETUP" mode and kept by the person in charge. In other cases, the
key should not be kept inserted.
• Do not set the [OPERATION] switch to the "SETUP" side un-
less any setup operations are performed.
When the [OPERATION] switch is set to the "SETUP" side, setup op-
erations become possible with the front safety door being open. It is
very dangerous to operate the machine without safety check. Be sure
to pay a special caution while operating the machine.
0307-004 17
AFO01EOPP
219'410
5612
56#46
'0#$.'
4705'672
12'4#6+10
.1%-
20.%*#0)'
Front Operation Panel
RUN SETUP
OPERATION
[OPERATION] Switch
Fig. 1X19
• Make certain that no one (or only part of body and clothes) or foreign
objects remain within the moving parts of the machine. Check safety
and power up the machine to start operating the machine.
Do not start the machine unless those working in the immedi-
ate area of the machine are aware of hazards from moving parts.
WARNING
0207-003 18 AFO01EOPP
2.3 Precautionary Items before Operation
• Only qualified personnel should come within the operating area of the
machine.
CAUTION
• Inspect the devices before starting the automatic operation.
CAUTION
• In principle, the buttons on the operation panel and the touch
screen must be operated by only one person.
If there are more than one, ensure good communication by giving loud
verbal instructions.
Fig. 1X20
• Do not use any unspecified tape and bulk feeders.
CAUTION
CAUTION
• After the machine has been stopped for a long period of time, follow the
steps below to smoothly start up the machine.
• Secure stable environmental condition (room temperature, etc.) for the
machine.
• Perform a running-in operation for approx. 30 minutes.
Refer to "8. Running-In Operation" in "Section 5" of "Vol. 2: Operation
(Supervisor)" for the detailed information on the running-in operation.
CAUTION
2.4 Precautionary Items during Operation
2.4 Precautionary Items during Operation
0207-004 19 AFO01EOPP
• When the tower light (green) is ON or flickering, it shows that the static
machine is in the "automatic" mode (awaiting mode).
CAUTION
WARNING
• When there is a problem with the machine, locate the cause and assess
the condition. After the problem has been rectified, turn off power supply
(if required) and follow reset procedures.
Refer to "Volume 4: Maintenance and Troubleshooting" for details.
Fig. 1X22
• Ensure personnel (part of body and clothes) and foreign objects remain
clear of the moving parts of the machine.
• Keep your face and hands away from any moving parts of the machine
during operation.
WARNING
Fig. 1X21