1OM-1050-002.pdf - 第49页
4.2 Module Protection Sensors This session describes the main sensors that are provided for ma- chine protection. 4.2.1 Feeder Installation Error Detection Sensors When a tape feeder is not installed correctly , these se…
4.1.4 [FEEDER CARRIAGE COVER] Safety Switch
Fig. 1X56 Rear View
The [FEEDER CARRIAGE COVER] safety switch is mounted inside
the cover as shown below.
Switch Name Countermeasures
4.1 Safety Switches
Fig. 1X56-1
Table 1X9
[FEEDER CARRIAGE COVER] Safety
Switch
• The power for operations cannot be sup-
plied with the feeder carriage cover being
open.
0210-002 46 AFO01EOPP
4.2 Module Protection Sensors
This session describes the main sensors that are provided for ma-
chine protection.
4.2.1 Feeder Installation Error Detection Sensors
When a tape feeder is not installed correctly, these sensors are used to prevent
the machine from being operated.
Sensor Name Symbol Countermeasures
Installation Error (+) BPX30
Installation Error (-) BPX31
Lifting Prevention (+) SQ2
Lifting Prevention (-) SQ3
Disengaged Latch (+) BPX27
Disengaged Latch (-) BPX28
4.2 Module Protection Sensors
Table 1X10
When one of the left sensors has detected an
error, the following measures are taken.
• The power to drive Feeder Carriages #1, #2,
#3, and #4 is shut off.
• The rotary turret stops after a cycle of opera-
tion.
Ref.: The rotary turret stops with its angle at
0° or 360°.
0301-003 47
AFO01EOPP
4.2.2 Feeder Carriage Collision Error Detection Sensors
When some feeder carriage collide with each other, these sensors are
used to stop the machine.
Sensor Name Symbol Countermeasures
Carriage Collision 12
BPH57
Carriage Collision 23 BPH58
Carriage Collision 34 BPH59
4.2 Module Protection Sensors
Table 1X11
When one of the left sensors has detected an error,
the following measures are taken.
• The power to drive Feeder Carriages #1, #2, #3,
and #4 is shut off.
• The rotary turret stops after a cycle of operation.
Ref.: The rotary turret stops with its angle at
0° or 360°.
0301-003 48
AFO01EOPP