CP-6-series Mechanical Reference.pdf - 第101页

1.10 Changing the Nozzle Filter (Every 3 Months) Point The filter inside of the shaft-axis becomes dirty with use, and as a general rule should be replaced with a new one every three months. Procedure W ARNING Turn off t…

Next remove the filter case and clean the filter element.

1. Disconnect the drain hose from the regulator if there is any.

2. Remove the filter case.

While pressing the lock down, turn to remove the filter case.

3. Remove the drainage collected in the filter case and wash the case with neutral

detergent.

4. Remove and clean the element.

Note: The element should be replaced every 2 years.

Assemble the filter regulator after cleaning, attach the air-hose, and open the valve lever

fully.

CP6ML007

O-ring

Lock knob Lock knob

Filter case

Filter regulator

AW3000-02-BDG

Mist separator

AFM3000-02-D

Model : 111585

Manufacturer : SMC

Filter element

Model : 630617

Manufacturer : SMC

Element assemby

Part 3 Chapter 1 Cleaning

Edition 1.6 3-1-9 CP-6-series Mechanical Reference

1.10 Changing the Nozzle Filter (Every 3 Months)

Point

The filter inside of the shaft-axis becomes dirty with use, and as a general rule should be

replaced with a new one every three months.

Procedure

WARNING

Turn off the 200 V servo power before carrying out this work.

1. Remove the nozzle holder. (Refer to Part 5, Chapter 1. Placing Heads.)

2. Take out the filter with a pair of tweezers.

Filter

CP6ML005E

Part 3 Chapter 1 Cleaning

Edition 1.6 3-1-10 CP-6-series Mechanical Reference

2. Lubrication

Precautions During Lubrication

1. Prior to beginning any work be sure to turn the main power breaker OFF.

2. Apply an appropriate amount of lubricant. If too much lubricant is applied the

lubricant will splatter and may drop on the boards or inside the machine. In

particular if the camera lens is dirtied this will lead to trouble such as vision

processing errors. If this happens use a lens cleaner to clean the lens.

Types of Lubricant

The lubricants that are used have the following properties.

Caution: Do not mix grease types.

CP6M3007a

Biral T&D

Daphne Eponex No. 2

Multemp LRL3

Multemp SRL

AFC grease

This is a spray type oil that is used as a lubricant in areas

such as the conveyor ballscrew, shaft components and

other moving parts that travel at a relatively slow speed and

upon which a relatively low load is exerted.

This is a lithium-based grease (Idemitsu) that is used as a

lubricant on moving parts that travel at moderate speeds.

This is a lithium-based grease (Kyodo Yushi) that is used as

a lubricant on moving parts that travel at moderate speeds.

This is a lithium-based grease (Kyodo Yushi) that is used as

a lubricant on moving parts that travel at high and moderate

speeds.

This is a high grade synthetic oil based grease (THK) is

used as a lubricant moving parts that travel at high speeds.

Types of Lubricants Properties

Part 3 Chapter 2 Lubrication

Edition 1.2 3-2-1 CP-6-series Mechanical Reference