CP-6-series Mechanical Reference.pdf - 第177页

Part 5 Chapter 3 Station Adjustments Edition 1.0 5-3-2 CP-6-series Mechanical Reference Rod Adjustment 1. Set an 8 x 4 mm tape feeder in the D1 position. 2. Press [SET] - [D pos.] - [1] - [CR] and the START button to mov…

Part 5 Chapter 3 Station Adjustments

Edition 1.0 5-3-1 CP-6-series Mechanical Reference

3. Station Adjustments

3.1 Station 1

Part Pick-Up

Station 1 is responsible for indexing the tape feeder and picking up parts.

3.1.1 Tape Feed Lever

The pitch lever is the mechanism that advances the feeder tape.

The vertical movement of this lever moves the tape to the pick-up location.

Two types of adjustment (rod and sensor adjustments) are required.

Adjustment rod

Roller

0.5 mm

Tape feed

lever

CP6M5014

Part 5 Chapter 3 Station Adjustments

Edition 1.0 5-3-2 CP-6-series Mechanical Reference

Rod Adjustment

1. Set an 8 x 4 mm tape feeder in the D1 position.

2. Press [SET] - [D pos.] - [1] - [CR] and the START button to move the feeder to

station 1.

3. Press [SET] - [MANUAL] - [I/O] and the EMERGENCY STOP button to take the

200 V down to 100 V.

WARNING

• Turn off the 200 V servo power before carrying out this work.

• Exercise extreme caution when working on the machine if the cam is

not at its origin (0 deg.). Recoil of the cam axis can endanger the

operator.

4. Use the cam handle to rotate the cam to 0°.

5. Switch the I/O (TAPE FEED SOL ON) setting ON.

6. Adjust the rod so that there is 0.5 mm clearance between the top of the pitch lever

and the roller. Access the rod from the cam box.

Retract sensor

Advance sensor

Tape feed lever

CP6M5015

Part 5 Chapter 3 Station Adjustments

Edition 1.0 5-3-3 CP-6-series Mechanical Reference

Advance Sensor Adjustment

1. When the dog is at the lower limit at cam angle 200°, ensure that the sensor is ON.

2. Set a dial gauge to the roller and adjust the sensor to go off 0.6 mm above the

lower limit.

Retract Sensor Adjustment

1. When the dog is at the upper limit at cam angle 0°, ensure that the sensor is ON.

2. Set a dial gauge to the roller and adjust the sensor to go off 0.3 mm below the

upper limit.

Dog upper limit

Dog lower limit

Dog

Retract sensor

0.3 mm

CP6M5017

0.6 mm

Dog upper limit

Dog

Dog lower limit

Advance sensor

CP6M5016