CP-6-series Mechanical Reference.pdf - 第95页

1.5 Cleaning the T ape Suction Path (Every 8 Hours) Point After the end of the tape is cut off by the cutter, it is drawn into the suction path in the course indicated by the arrows. If this area becomes blocked by waste…

1.4 Cleaning the Waste Tape Box (Every 8 Hours)

Point

Tape cut by the waste tape cutter travels through a tube to the waste tape box. Empty

the waste tape box every eight hours, as a large amount of waste tape collects after eight

hours of production.

Procedure

When cleaning out the waste tape box, check the filter above it, and if necessary, clean

the filter with a vacuum cleaner.

Filter

Waste tape box

CP6M3003

CP-652C

Part 3 Chapter 1 Cleaning

Edition 1.6 3-1-3 CP-6-series Mechanical Reference

1.5 Cleaning the Tape Suction Path (Every 8 Hours)

Point

After the end of the tape is cut off by the cutter, it is drawn into the suction path in the

course indicated by the arrows. If this area becomes blocked by waste tape, tape feed

will be impeded and part pick-up will be unreliable.

Procedure

WARNING

Turn off the 200 V servo power before carrying out this work.

Inspect this area for blockage if tape feed abnormalities cause pick-up errors during

automatic production.

Do not use an air gun to blow out any waste tape that becomes clogged in the duct but

rather use a vacuum cleaner to suck the waste tape out.

Duct pipe

Feeder

CP6M3004

Part 3 Chapter 1 Cleaning

Edition 1.6 3-1-4 CP-6-series Mechanical Reference

1.6 Cleaning the Camera Cover Glass (Every Week)

Point

Oil or dirt on the surfaces of the prisms can lead to problems such as reduced light

strength and distortion of the image. This may affect the placing accuracy.

Procedure

WARNING

Turn off the 200 V servo power before carrying out this work.

Use a soft brush (such as those used to clean camera lenses) to clean the camera glass. If

the glass is badly soiled, use a commercially available glass cleaner.

CAUTION

Take care to not bend any nozzles.

Do not place excessive pressure on the camera cover glass, which is

thin and breaks easily.

C7SM3010a

Camera cover glass

Part 3 Chapter 1 Cleaning

Edition 1.6 3-1-5 CP-6-series Mechanical Reference