CP-6-series Mechanical Reference.pdf - 第23页
Safety Guidelines Edition 1.5 9 CP-6-series Mechanical Reference Make sure the cam is at its origin (0 deg.) ● Exercise extreme caution when working on the machine if the cam is not at its origin (0 deg.). (The cam may n…
Safety Guidelines
Edition 1.5 8 CP-6-series Mechanical Reference
3. Safety Rules for Individual Machine Types
CP-6-series Machines
WARNING
Do not reach into the machine over the rear fence
during operation.
● Body parts or clothing may be caught in the machine causing
personal injury.
Do not enter within the safety fence, even in cases of an
emergency stop.
● When an emergency stop occurs in step mode, power to the servo
amps is only cut after all axes have stopped moving. As a result,
there may be a short delay between the moment the emergency
arises and the power to the servo amps is turn off.
● Do not enter the safety fence immediately following an emergency
stop, body parts or clothing may be caught in the machine causing
personal injury.
Do not operate the machine after removing the
transparent shutters from the D-axis.
● Body parts or clothing may be caught in the machine causing
personal injury.
Do not lean on the in- and out-conveyors during
operation.
● During operation do not lean on or across the in- and out-conveyors
to check the feeders.
Turn the power off when inspecting the cam box.
● When inspecting the upper part of the cam box, turn off the power
to the machine and exercise sufficient caution.
Safety Guidelines
Edition 1.5 9 CP-6-series Mechanical Reference
Make sure the cam is at its origin (0 deg.)
● Exercise extreme caution when working on the machine if the cam
is not at its origin (0 deg.). (The cam may not stop at its origin (0
deg.) in an emergency stop.) Recoil of the cam axis can endanger
the operator.
● If the cam is not at its origin (0 deg.), use a crank to rotate the cam
shaft until the indicator points to 0 degrees.
Do not stare into the laser beam.
● The CP-643E/CP-643ME is equipped with laser type fiber sensors
(class 2). Exercise extreme caution when working in areas where
there is a risk of eye damage from the laser beams.
Do not touch the high voltage section within the
machine's control box.
● The Brown tube section within the machine's control box contains
high voltage wiring. Do not insert your hand or any metal object into
this part as it may cause electrical shock.
WARNING
4. Safety Labels
To warn the operator of hazards, safety labels are attached to the machine at the
positions indicated in the figure below.
Familiarize yourself with each label and its message before operating the machine.
Front Side of the Machine
<CP-6/6E, CP-6M/6ME, CP-642/642E, CP-642M/642ME, CP-
65/65E>
1
2
3
4
1
1
Never insert your hand
inside an operating machine.
Moving parts may cause injury.
DANGER
3
Same for left side
4
5
<WARNING>
DISCONNECT POWER PRIOR TO SERVICING
5
Keep hands and
clothing well clear
of the moving conveyor
2
1
High Voltage
6
<CAUTION>
AN EXPLOSION MAY OCCUR IF THE BATTERY IS NOT REPLACED
PROPERLY. USE THE BATTERY TYPE SPECIFIED BY FUJI (OR
EQUIVALENT BATTERY TYPE).USED BATTERIES MUST BE
DISCARDED FOLLOWING THE MANUFACTURER'S INSTRUCTIONS.
6
m-059
WARNING
THE BYPASS KEY OVERRIDES
SAFETY DOOR INTERLOCKS.
EXERCISE EXTREME CAUTION
DURING USE
Safety Guidelines
Edition 1.5 10 CP-6-series Mechanical Reference