CP-6-series Mechanical Reference.pdf - 第80页

3. Use the appropriate feeder type according to part type. Incompatible part tape makes it impossible to close the tape leaf correctly. CP6M2003 Correct Incorrect Part 2 Chapter 2 Feeder Setting Edition 1.0 2-2-2 CP-6-se…

2. Feeder Setting

Point

The feeder must be correctly set on the device table in order for parts to be accurately

picked by the nozzles.

Procedure

WARNING

Turn off the 200 V servo power before carrying out this procedure.

Check that the feeders are correctly set on the device table or the pallet (CP-652C) as

described below.

1. Ensure that no foreign matter (waste paper, dust, etc.) becomes sandwiched

between the feeders and the device table. Remove any foreign matter from the

device table and the bottom of the feeder before setting feeders.

2. Check for any tape leaf deformities.

Feeder

Foreign matter

Device table

CP6M2002

Part 2 Chapter 2 Feeder Setting

Edition 1.0 2-2-1 CP-6-series Mechanical Reference

3. Use the appropriate feeder type according to part type.

Incompatible part tape makes it impossible to close the tape leaf correctly.

CP6M2003

Correct Incorrect

Part 2 Chapter 2 Feeder Setting

Edition 1.0 2-2-2 CP-6-series Mechanical Reference

3. Setting the Back-up Pins

Point

Position the back-up pins in accordance with the shape and size of the board being

produced considering the position of any parts that are pre-mounted on the underside of

the board.

When possible, back-up pins or rubber blocks (shock-free back-up; CP-642/643 series

only) should be used to ensure stable placing accuracy.

Procedure

1. Execute the following command operation to move the XY-table to the loading

position. [LOADER] - [LOADING PSTN] - START button.

2. Press [LIFTER ▲] - START button to raise the XY-table.

3. Press the EMERGENCY STOP button.

WARNING

Turn off the 200 V servo power before carrying out this work.

4. Set the back-up pin to the specified height as shown in the figure below.

When using rubber blocks (CP-642/643 series only):

Cut the rubber block into segments of the required length, and affix the segments

to the plate using double-sided tape.

CP6M2005

20 mm

39.2 mm

Part name: Shock free back-up

Part No.: CSSZ0550

Mounting screw

Bottom surface of board

Top surface of back-up pin plate

Lock nut

CP6M2004

Models

CP-6

CP-642/643

CP-65/652C

Reference value (mm)

41 – (Board thickness)

39.2

Back-up pin height

Part 2 Chapter 3 Setting the Back-up Pins

Edition 1.0 2-3-1 CP-6-series Mechanical Reference