CP-6-series Mechanical Reference.pdf - 第172页

Part 5 Chapter 2 Cam Box Edition 1.6 5-2-3 CP-6-series Mechanical Reference 2.2 Cam Origin Dog Adjustment (Cam Box) There is a cam axis origin dog on camshaft A. With the cam angle at 0°, match the center of the dog with…

Part 5 Chapter 2 Cam Box

Edition 1.6 5-2-2 CP-6-series Mechanical Reference

<5000 Type>

There are five timing belts in the cam box. Most of the belts have a jack bolt for tension

adjustment. Refer to the figure below for belt tension values.

(a)

(d)

(c)

(b)

(e)

90 ± 5 Hz

198 ± 5 Hz

69 ± 5 Hz

57 ± 5 Hz

121 ± 5 Hz

CP6M5009a

Motor

(e)

(a) (b)

(c)

(d)

CP6M5008

Part 5 Chapter 2 Cam Box

Edition 1.6 5-2-3 CP-6-series Mechanical Reference

2.2 Cam Origin Dog Adjustment (Cam Box)

There is a cam axis origin dog on camshaft A. With the cam angle at 0°, match the center

of the dog with the center of the sensor.

WARNING

• Turn off the main power before carrying out this work.

• Exercise extreme caution when working on the machine if the cam is

not at its origin (0 deg.). Recoil of the cam axis can endanger the

operator.

Part 5 Chapter 2 Cam Box

Edition 1.6 5-2-4 CP-6-series Mechanical Reference

2.3 Cam Lever Stopper Adjustment (Cam Box)

The cam lever stopper operates through the movement of the air cylinder. Usually the

air cylinder is in the retract position. At this position the cam operates. When the air

cylinder is in the extended position, the lever action is stopped.

The stoppers are used on the following seven functions.

Station 1 UP & DOWN NOZZLE

Station 1 FWRD & BWRD, FEEDING JAW

Station 3 UP & DOWN CLUTCH

Station 10 UP & DOWN, F•θ

Station 11 UP & DOWN, NOZZLE

Station 13 UP & DOWN, PR•θ

Station 18 FWRD & BWRD, KNOTCH

Adjustment procedure

WARNING

• Turn off the 200 V servo power before carrying out this work.

• Exercise extreme caution when working on the machine if the cam is

not at its origin (0 deg.). Recoil of the cam axis can endanger the

operator.

1. Set the cam to 0°.

2. Change the cylinder from the retract position to the extend position.

3. Attach a dial gauge to the end of the cam lever and set to zero.