CP-6-series Mechanical Reference.pdf - 第310页

7. Setting the Board Positioning Pins When a reference pin and follow-up pin are used, the positioning pins must be reset each time the size of boards being transported changes. The following pin positions must be set. •…

5. Secure the reverse flow board stopper in a position 3.0 mm from the rear edge of

the second board.

6. Check the positions of premounted parts on the lower surface of the board.

7. Set the sensor to avoid premounted parts.

Loosen the bolt shown in the figure below, move the slider in the Y-direction and

adjust the sensor position.

CP6M10034

Lock bolt

Slider

Premounted

parts

Sensor

Y-direction

CP6M10033

Adjustment boltReverse flow board stopper

Second board First board

5.0 mm0.2~0.3 mm

15.0 mm

220.0 mm

3.0 mm

Part 9 Chapter 6 Out-Conveyor

Edition 1.0 9-6-4 CP-6-series Mechanical Reference

7. Setting the Board Positioning Pins

When a reference pin and follow-up pin are used, the positioning pins must be reset each

time the size of boards being transported changes.

The following pin positions must be set.

• First board follow-up pin position

• Second board reference pin position

• Second board follow-up pin position

WARNING

• Turn off the 200 V servo power before carrying out this work.

• The CP-643E/643ME conveyor is equipped with laser sensors.

In areas where there is a risk of eye damage from the laser beams,

be sure to install a laser beam shield at the laser emission area

before performing this sensor adjustment procedure.

Push down on the lock lever to move the pin holder and adjust the pin position to match

the board pin pitch. Also be sure to take the gap between the first and second boards

into account when setting each positioning pin.

CP6M10036

Lever

CP6M10035

First board follow-up pin

Second board reference pin

Second board follow-up pin

Part 9 Chapter 7 Setting the Board Positioning Pins

Edition 1.0 9-7-1 CP-6-series Mechanical Reference

Notes:

Part 9 Chapter 7 Setting the Board Positioning Pins

Edition 1.0 9-7-2 CP-6-series Mechanical Reference