CP-6-series Mechanical Reference.pdf - 第206页

Nozzle DOWN Limit Sensor Note: When performing the DOWN limit sensor adjustment after the UP limit sensor adjustment, remove the dial gauge from the machine to avoid interference between the dial gauge and the cam lever.…

5. Adjust the sensor’s mounting position by loosening the sensor lock screws and

sliding the sensor in the front/back directions.

CP6M5049

Sensor

Lock screws

Dog

Part 5 Chapter 3 Station Adjustments

Edition 1.0 5-3-30 CP-6-series Mechanical Reference

Nozzle DOWN Limit Sensor

Note: When performing the DOWN limit sensor adjustment after the UP limit sensor adjustment,

remove the dial gauge from the machine to avoid interference between the dial gauge and

the cam lever.

1. Set the cam axis to the 180-degree position.

2. Execute the following I/O commands to pull in the ST 11 placing stop cylinder

(located in the cam box):

[SET] - [MANUAL] - [I/O] - [Standard I/O] - [OUTPUT] -> Y028 PLACE SOL ON

The cam lever will then follow the cam axis.

3. Place a dial gauge on the nozzle UP/DOWN rod and set the gauge reading to “0”.

In this condition, the cam axis will be at its 180-degree position, and the nozzle

UP/DOWN rod will be at its DOWN limit position. Verify that the nozzle DOWN

limit sensor is ON (I/O INPORT X03F ST11 DN POS is ON).

CP6M5051

Nozzle DOWN limit sensor ON

Dog

Nozzle UP/DOWN rod

Set dial gauge to “0”

Solenoid valve

ST11 placing stop cylinder

Cam lever

Cam axis

CP6M5050

Part 5 Chapter 3 Station Adjustments

Edition 1.0 5-3-31 CP-6-series Mechanical Reference

4. While observing the dial gauge, rotate the cam axis in the forward direction to

raise the nozzle UP/DOWN rod. Adjust the sensor’s mounting position so that

the sensor switches OFF (I/O INPORT X03F ST11 DN POS switches OFF) when

the rod has been raised 0.3 to 0.4 mm.

5. Adjust the sensor’s mounting position by loosening the sensor lock screws and

sliding the sensor in the front/back directions.

CP6M5053

Sensor

Lock screws

Dog

CP6M5052

Nozzle DOWN limit sensor OFF

Dog

Rod raised

0.3 to 0.4 mm

Part 5 Chapter 3 Station Adjustments

Edition 1.0 5-3-32 CP-6-series Mechanical Reference