X7056_Operating manual_en.pdf - 第240页
Packing Safety 240 Inspection system X7056 | Operating manual | Version 3.1 Rev.006| 2016-01-06 | 30.009.1930a Safety Follow these instructions when packing the system: For packing, use a sufficiently l arge surface th…
Packing 239
Inspection system X7056 | Operating manual |
Version 3.1 Rev.006| 2016-01-06 | 30.009.1930a
Packing
This chapter describes how to pack the inspection system, step by
step.
It contains the following sections:
Safety (Page 240)
Packing the inspection system (Page 241)
Storage (Page 249)
Disposal (Page 250)
Packing
Safety
240
Inspection system X7056 | Operating manual |
Version 3.1 Rev.006| 2016-01-06 | 30.009.1930a
Safety
Follow these instructions when packing the system:
For packing, use a sufficiently large surface that is protected
from moisture.
Only use original Viscom accessory parts (transportation safety
devices and screws) to secure the positioning unit.
Only use original Viscom accessory parts (transport clamps and
screws) to secure the inspection system to the wooden pallet.
To load the system, follow the specifications in the transport
manual.
For all work on and with the system and during disposal,
observe all local legally mandated guidelines for waste preven-
tion and appropriate recycling and disposal.
Packing
Packing the inspection system
241
Inspection system X7056 | Operating manual |
Version 3.1 Rev.006| 2016-01-06 | 30.009.1930a
Packing the inspection system
Always pack the inspection system for storage or transport. This
chapter describes how to pack the system.
It contains the following sections:
Preparing the wooden pallet (Page 241)
Securing the lift door (Page 242)
Setting the system feet (Page 242)
Fastening the inspection system (Page 243)
Wrapping the inspection system (Page 245)
Packing the inspection system in the transport case (Page 248)
Transporting the inspection system (Page 248)
Preparing the wooden pallet
Required: Wooden pallet
Aluminum laminate sheet and bag
ATTENTION
Damage to the inspection system
There are power supply cables on the front and back sides of the
inspection system.
Make sure that no cables are underneath the system.
Perform the following work steps:
1. Lay out the aluminum laminate sheet on the wooden pallet with
the aluminum side down.
2. Set the inspection system carefully in the middle of the wooden
pallet.
The wooden pallet is prepared.