X7056_Operating manual_en.pdf - 第246页
Packing Packing the in spection system 246 Inspection system X7056 | Operating manual | Version 3.1 Rev.006| 2016-01-06 | 30.009.1930a 3. Place a layer of bubble wrap over the inspection system. The front and rear side…
Packing
Packing the inspection system
245
Inspection system X7056 | Operating manual |
Version 3.1 Rev.006| 2016-01-06 | 30.009.1930a
Wrapping the inspection system
Precondition: Signal lamp is removed.
The system is cleaned.
The inspection system is fastened to the pallet with transport
clamps.
Required: Bubble wrap and plastic stretch wrap
Aluminum laminate sheet and bag
Packing tape
Drying agent
Cordless screwdriver
Vacuum cleaner
Foil sealer
Placing the
drying agent
Perform the following work steps:
Place a sack of drying agent beneath the inspection system.
The drying agent is placed.
Wrapping the
inspection
system with
foil.
Perform the following work steps:
1. Wrap the monitor bracket with bubble wrap.
2. Fasten the bubble wrap with packing tape.
Packing
Packing the inspection system
246
Inspection system X7056 | Operating manual |
Version 3.1 Rev.006| 2016-01-06 | 30.009.1930a
3. Place a layer of bubble wrap over the inspection system.
The front and rear sides of the inspection system are covered
with bubble wrap.
4. Completely wrap the inspection system with bubble wrap.
5. Fold in the monitor bracket.
6. Set the accessories cartons to the front and on the side of the
inspection system.
7. Completely wrap the system with two layers of stretch wrap.
The inspection system is wrapped with bubble wrap and stretch wrap.
Packing
Packing the inspection system
247
Inspection system X7056 | Operating manual |
Version 3.1 Rev.006| 2016-01-06 | 30.009.1930a
Packing the
inspection
system airtight
Perform the following work steps:
1. Completely cover the inspection system with the aluminum
laminate bag.
2. Heat-seal the aluminum laminate bag to the bottom layer of
aluminum laminate on the wooden pallet.
Leave an opening of approx. 5 cm for pumping out the air.
3. Insert the vacuum cleaner hose into the opening and remove
the air from the foil laminate bag.
The air is completely pumped out.
4. Remove the vacuum cleaner hose.
5. Heat-seal the opening with the foil sealer.