1OM-1075-002.pdf - 第107页

AHB01EOPP (3) Press the [Origin/Signal Info.] tab to open the [Origin/Signal Info.] tab sheet and perform the zeroing operations. Fig. 1C1 1 "Origin/Signal Info." T ab Sheet (Provided with Multi-Layer T ray Fee…

AHB01EOPP0308-003 3-8

1.2.2 "AUTO OPN." Windows and Zeroing of Each Device

(1) Enter the password and press the [OK] button.

Main menu bar and "AUTO OPN." window are displayed in the touch

screen.

Fig. 1C10

(2) Wait for a few seconds until the lamp of the [READY] button illumi-

nates in green.

1.2 Preparation before Operation

AHB01EOPP

(3) Press the [Origin/Signal Info.] tab to open the [Origin/Signal Info.]

tab sheet and perform the zeroing operations.

Fig. 1C11 "Origin/Signal Info." Tab Sheet (Provided with Multi-Layer Tray Feeder #2)

(a) The tab sheet may look different, depending on which op-

tions are selected.

(b) When "z" marks are not displayed for all devices other than

"Conv. Wid. Adj. Axis" in the "Origin Information" group box

of the "Origin/Signal Info." tab sheet, the automatic opera-

tion of the machine cannot be started.

Fig. 1C12 Origin Information (Provided with Multi-Layer Tray Feeder #2)

When "z" mark is not displayed for a device (s) other than "Conv. Wid.

Adj. Axis", follow the operation procedure below to perform a zeroing

operation for the device (s).

1.2 Preparation before Operation

0308-003 3-8-1

Note

AHB01EOPP

Operation Procedure

1. Confirm that the machine is set in the "STOP" mode.

2. Confirm that the front and rear safety doors are closed.

Confirm that the lamp of the [READY] button illuminates in green.

Otherwise, press the [READY] button and wait until the lamp illumi-

nates.

3. When the [ENABLE] button on the operation panel is pressed in 2

seconds after the [ALL] button (entitled "ZERO"), all devices except

"Conv. Wid. Adj. Axis" (one of the devices displayed in the "Origin

Information" group box of the "Origin/Signal Info." tab sheet) are ze-

roed.

Zeroing: The lamp of the [START] button illuminates.

Zeroing Completed: The lamp of the [START] button flick-

ers.

1.2 Preparation before Operation

0206-003 3 - 9

Note