SYS-CP842-1.1E.pdf - 第134页
SYS-CP842-1.1E 3.Machine System CP-842E / CP-842ME System Reference 125 Management] screen an d perform a test readi ng of the panel ID barcode, and fine-adju st the barcode reader positio n until the barcode is being re…
3.Machine System SYS-CP842-1.1E
124 CP-842E / CP-842ME System Reference
Fujitrax-Profiler Settings
Perform the same setting procedures for code reading by the mark camera.
Barcode Reader Adjustment
The barcode reader position must be adjusted to accommodate a production panel change,
or changes in the panel ID barcode position. In such cases, adjust the reader to a position
where normal reading can occur.
Adjust the following as necessary:
Position (Y-direction), Height (33 mm 5 mm)
Barcode reader tilt
(A tilt of 10~40 degrees, 15~40 degrees is required. See the illustration below.)
Barcode reader orientation (parallel or perpendicular to conveyance direction).
View from above in-conveyor
View of in-conveyor from left side of machine
Barcode Reading Test
After adjusting the barcode reader to its approximate position, open the [Barcode
Barcode reader
orientation adjustment
Position adjustment
Barcode reader
Trigger sensor
In-conveyor
In-conveyor
Production panel
Barcodes
Barcode reader
Tilt adjustment
(15 ~ 40 deg.)
Tit adjustment
(10 ~ 40 deg.)
Height adjust
(33 mm ± 5 mm)
SYS-CP842-1.1E 3.Machine System
CP-842E / CP-842ME System Reference 125
Management] screen and perform a test reading of the panel ID barcode, and fine-adjust
the barcode reader position until the barcode is being read properly.
Place a panel on the conveyor, then press [Test Start or End]. Fine-adjust the reader
position until the reading success rate is high (approx. 100%).
Reading Trigger Sensor Adjustment
When the position of the panel ID changes due to a production panel change, etc., the
9 Selects the reader (upper or lower) to be used for reading test
10 Indicates the reader (upper or lower) being used for reading test.
11 Switches the test mode being used for reading test.
12 Indicates the current test mode being used for reading test.
13 Starts and stops the test.
14 Display area for reading success rate / success count.
15 Display area for content of barcode which was read.
9
10
11
12
13
14
15
%1/
3.Machine System SYS-CP842-1.1E
126 CP-842E / CP-842ME System Reference
sensor which triggers barcode reading is moved together with the barcode reader. In some
cases, however, changes in the production panel and the panel ID position may result in a
panel color or shape which prevents stable detection of the panel edge, and the sensor may
fail to trigger the barcode reading operation.
In such cases, the reading trigger sensor must be adjusted so that reading is triggered in a
stable manner before the panel has moved past the sensor.
Adjust the following as necessary:
• Position (Y-direction)
• Height
In-conveyo
r
Production panel
Barcode reader
Height adjustment
Position (Y-direction) adjustment
Trigger sensor